User manual DALI LEKTOR

[. . . ] For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet, that may impede the flow of air through the ventilation openings. Heat - the appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances that produce heat. 11 Power cord protection - power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed on or against them, paying particular attention to cords at plugs, convenience receptacles and the point where they exit from appliance. 12 Cleaning - do not use any liquid cleaners. [. . . ] By parallel positioning, the distortion in the main listening area will be lowered and the room integration will be better. The wide dispersion principle will also ensure that sound is spread evenly within a large area in the listening room. Every room has its own distinctive acoustics, which influence the way we experience sound from a speaker. The sound you hear consists of direct sound from the speakers and reflected sound from the floor, ceiling and walls. the latter will affect how you experience the sound. As a basic rule, try to avoid large, hard and reflective areas in the immediate vicinity of your loudspeakers as it will typically cause strong reflections, which might disturb the precision and spatial effect of the sound reproduction. Both the amount and quality of the deep bass depend on the size and shape of the room, and the position of the speakers. Positioning the speakers near a side or back wall will accentuate the bass. A corner location will accentuate it even more, but will also increase the reflections. The surfaces of the speakers may fade over time when exposed to direct sunlight. DALI products are designed to meet the international directives concerning Restriction of Hazardous Substances (RoHS) and disposal of Waste Electrical and Electronic Equipment (WEEE). The waste symbol indicates that the speakers meet the directives, see Figure 1. the speakers must be processed or recycled appropriately. Please consult your local waste authority for guidance. You should expect the sound quality from your new speakers to gradually improve during the first period of use. Nothing particular has to be done in order to run in the speakers ­ but expect up to 100 hours of playback (depending on playback level) before full performance level is reached. 1 LEKTOR 1/2/3/LCR The speakers can be positioned on a stand/shelf or hung on a wall using the integrated wall bracket(s). If positioned on a stand or shelf, the enclosed rubber bumpers can be mounted under the speaker for stable and vibration free positioning, see Figure 2A. if hung on a wall , mount the bumpers on the rear edge of the speakers , see Figure 2B. The speakers are hung on a wall using one or two screw(s) mounted in the wall. The screw(s) must fit the wall bracket(s) on the rear side of the speaker, see Figure 2C. LEKTOR LCR can be hung vertically if used as left/right/rear speaker, or horizontally if used as center channel speaker. [. . . ] "Crossover" adjustment: adjust the overlap between the subwoofer and the main speakers by adjusting "Crossover" up and down until you hear the bass is smooth and without "holes". You may need to readjust the Volume setting (4) slightly after this adjustment. To connect the subwoofer to your stereo or surround sound system, please consult the owner's manual for your stereo/surround sound amplifier to locate a subwoofer output terminal or a pre-out output terminal. The subwoofer must be connected to the amplifier using a RCA cable (sold separately). [. . . ]