User manual DALLEE ELECTRONICS APPLICATION NOTES WIRING
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual DALLEE ELECTRONICS APPLICATION NOTES WIRING. We hope that this DALLEE ELECTRONICS APPLICATION NOTES WIRING user guide will be useful to you.
Lastmanuals help download the user guide DALLEE ELECTRONICS APPLICATION NOTES WIRING.
Manual abstract: user guide DALLEE ELECTRONICS APPLICATION NOTES WIRING
Detailed instructions for use are in the User's Guide.
[. . . ] Using a DC-V3 sound system with standard AC track power and conventional E-Unit.
It is possible to use this sound system with a conventional E-Unit with AC track power. However, Horn/Whistle, Bell, and other sound operations require the use of the LocoMaticTM Controller (#755). The main sounds, such as the prime mover for diesel's, exhaust chuff's for steam, and cooling fans for electic's, will work without the controller. [. . . ] If your engine has a series motor, these wires would be the brush wires. Field wires would remain connected as normal.
Use 1. 5 amp choke, item 702, as supplied with sound system or item 703 for larger motor loads.
8 ohm speaker
M
White
motor leads from E-Unit. Brown
E-Unit
(electronic or mechanical)
Blue
2 rail - connect to right rail pickup.
Choke Black
3 rail - connect to center rail pickup.
Track Power input DC-V3 Sound Unit
+ +
Capacitors +
To J2 power. Observe polarity!
+
EMD's require two or more capacitors rated at 4700mfd@25 (item 205). For tighter fits, use four 2200mfd@25 (item 206). All capacitors should be wired in parallel. The higher the volume, the more capacitance you need to keep the sound unit alive during sequence operation.
Red 2 rail - connect to left rail Gray pickup. "dot" denotes connection 3 rail - connect to outside rail, Red chassis, pickup. J2, DC power, needs to be connected to either a capacitor or a 9 volt Note: Track power input wire connections Gray battery with a switch. A rechargeable 9 volt battery may be used. Two Diagrams below show the various configurations required. Without a rail operators may switch which is storage element, as shown below, the sound system will reset on each which for ease of installation. power interruption and have distortion or no sound at low track voltages. E-Unit wire colors are shown for a Proper polarity must be observed! [. . . ] Shown in the OFF position.
+
8. 4V rechargeable battery, #647
with the power switch on you can fully charge a battery by leaving the e-unit in neutral, track voltage above 10 volts and press 'alt- forward' for "main sounds off" (not req. A full charge requires 14 hours.
246 W. Leola, PA 17540 (717) 661-7041 www. dallee. com [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DALLEE ELECTRONICS APPLICATION NOTES WIRING
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual DALLEE ELECTRONICS APPLICATION NOTES WIRING will begin.
