User manual DALLEE ELECTRONICS ELECTRIC LOCOMATIC SOUND TYPE 3

[. . . ] LocoMaticTM type3 ELECTRIC Sound & Control for AC or DC track power by Instructions rev 1. 2 CAUTION: this device can be damaged by static discharge. please exercise care during installation to avoid this possibility. discharge yourself to an electrical ground (outlet cover screw) before removing this device from its anti-static bag. please read instruction sheet completely before attempting to install and operate this product. INSTALLATION INSTRUCTIONS: This sound / control system consists of a main printed circuit board with an additional small circuit board attached by a wire harness. [. . . ] Mars / Strobe Lighting Effects with the LocoMaticTM Controller: This LocoMaticTM Sound & Control System is equipped with a Mars or Strobe lighting effect. They are selected with the LocoMaticTM controllers Alt-Horn button. To activate the Mars light press and release the Alt-Horn button. If the headlight is on, then the Mars light effect will start. If the Headlight is off the Mars light effect will start when the Headlight comes on. When the Mars light is on and the Headlight goes off, as in normal sequence operation, the Mars light will also go off. If you want the Mars light to stay on, merely enter manual lighting operation by turning on the Headlight. Since the Mars light follows the headlight operation, A-A operation is not compromised when selection switch 6 is placed ON. This way only the locomotive with the Headlight on will have the Mars light operational. To activate the Strobe light function press and release the Alt-Horn button twice, with a pause between presses. The first activation starts the Mars light. The second activation starts the Strobe light. The Strobe light operates whenever the LocoMaticTM except that the locomotive will no longer respond to the whistle and bell controls on your transformer. Lowering the voltage on your transformer will only effect a reduction in the top speed possible. The FORWARD, REVERSE and SLOW buttons are now speed and direction controls. Press and release either FORWARD or REVERSE and your locomotive will begin in that direction. With each, approximately 1/2 second, momentary button activation the speed will increase one step through a total of 24 steps. Holding a button "on" will continuously increase through the steps to full speed. To slow down you can activate or hold the SLOW button through the steps to a stop. You can also slow down by using the opposite direction button. If the locomotive is in forward direction and you hold the REVERSE button, the locomotive will slow to a stop and then accelerate in reverse. Similarly, if running in reverse, holding the FORWARD button will result in a slow to stop and then an acceleration in forward. [. . . ] CHOKE (Coil) Input Output To install the choke in 3-rail passenger cars with multiple pickups: 1 . . . . . . remove the existing center roller pickup wires. connect these wires together to form a common wire. place a new wire from one truck roller to the second truck roller. [. . . ]