Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual DALLEE ELECTRONICS RL-ADJ V2 LIGHTING. We hope that this DALLEE ELECTRONICS RL-ADJ V2 LIGHTING user guide will be useful to you.
Lastmanuals help download the user guide DALLEE ELECTRONICS RL-ADJ V2 LIGHTING.
Manual abstract: user guide DALLEE ELECTRONICS RL-ADJ V2 LIGHTING
Detailed instructions for use are in the User's Guide.
[. . . ] The RL-ADJ is completely compatable with our DC sound systems, LocoMatic sound systems, and all standard AC, DC, and DCC track power with NO extra items required. The maximum input voltage is 25 volts AC, 30 volts DC. INSTALLATION: All REGULATED LIGHTING devices are to be mounted where space permits. [. . . ] Extra lamps can be purchased as item #383. There are 16 lamp mounting provisions on the board. The board is also designed to be broken into sections with jumper wire locations provided. The breaking locations are shown by dashed lines with extra holes drilled through the board to provide an easier break. If breaking the unit into sections, 2 wires are required between to continue power to the next section. If connectors for the end pieces are desired, item #520 will match the predrilled holes. If the end section is not required, discard it or keep it for another application. As always with electronics, use only rosin core solder or others appropriate for electronics, paste solder fluxes, including rosin pastes such as "NOKORODE" will eventually destroy wires and printed circuit boards. All soldering is to be done with an appropriate low wattage pencil tip iron. After the lamps have been placed into their appropriate locations, peel the double sided tape and adhere to a clean surface. If more double sided tape is required it can be purchased as item #388. Item 388 is a proper tape for use with electronic equipment. We also offer 1. 5 and 5 volt lamps with wire leads which can also be used on this regulator as well. Things to look for when installing: 2 rail operators: should make sure the pickup wheels are on the same side of each truck. If not, a short will occur when the car is placed on the track. Make sure each truck picks up from an opposite rail. [. . . ] You might also consider placing reflective metal duct tape along the inside roof to reflect the light downward within the car. Leola, PA 17540 (717) 661-7041 www. dallee. com
RL-ADJ Item #379
3. 75 If two miniature 1. 5 volt lamps are needed, simply place them in series and connect them to one of the lamp positions on the lighting board. 2. 7 4. 75 cut lines To use LED's place them with the correct polarity in series with an appropriate resistor. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE DALLEE ELECTRONICS RL-ADJ V2 LIGHTING
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual DALLEE ELECTRONICS RL-ADJ V2 LIGHTING will begin.
