User manual DANA 4900-6

[. . . ] Remove the washing machine from its packaging. Make sure that the washing machine has not been damaged during the transportation process. If it has been damaged, contact the retailer and do not proceed any further with the installation process. Remove the 4 protective screws (used during transportation) and the rubber washer with the corresponding spacer, located on the rear part of the appliance (see figure). [. . . ] Load (kg) Cycle duration 1 2 2 3 4 4 5 6 6 7 8 9 Silk/Curtains: for garments in silk and viscose, lingerie. Mix 15’: to refresh lightly soiled garments quickly (not suitable for wool, silk and clothes which require washing by hand). Shirts 90° 60° 40° 40° 60° 40° 30 90° 60° 40° 40° 30° 40° Cold Water Cold Water Cold Water - 1200 1200 1200 1200 800 800 800 1200 1200 800 600 0 600 1200 800 800 1200 1200 0 8 8 8 8 4 4 1, 5 8 8 4 2 2 2 8 3 3 8 8 8 For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 60456: set wash cycle 6 with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle 2 with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle 3 with a temperature of 40°C. The information contained in the table is intended as a guide only. Specials wash cycles Mix 15’(wash cycle 5) this wash cycle was designed to wash lightly soiled garments quickly: it lasts just 15 minutes and therefore saves both energy and time. By selecting this wash cycle (5 at 30°C), it is possible to wash different fabrics together (except for wool and silk items), with a maximum load of 1. A high-temperature hygienic wash cycle (over 60°C) which requires the use of bleach. Pour the bleach, the detergent and the additives into the relevant compartments (see paragraph entitled “Detergent dispenser drawer”). This is a silent cycle which can be run at night, when the electricity prices are lower. Extra rinse By selecting this function, the efficiency of the rinse is increased and optimal detergent removal is guaranteed. This function may not be used in conjunction with wash cycles 5, 13, B. Easy iron By selecting this function, the wash and spin cycles will be modified in order to reduce the formation of creases. At the end of the cycle the washing machine will perform slow rotations of the drum; the EASY IRON and START/PAUSE indicator lights will flash (orange) and the phase will remain lit in a fixed manner. To end the cycle, press the START/PAUSE button or the EASY IRON button. For the Silk wash cycle, the machine will end the cycle while the laundry is soaking, the EASY IRON and START/PAUSE indicator lights will flash (orange) and the RINSE phase will remain lit in a fixed manner. To drain the water so that the laundry may be removed, press the START/PAUSE button or the EASY IRON button. This function may not be used in conjunction with wash cycles 5, 6, 7, 10, 11, 12, 13, B. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washing machine performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. [. . . ] Possible causes / Solutions: • The appliance is not plugged into the socket fully, or is not making contact. €¢ There is no power in the house. €¢ A delayed start has been set (using the Delay Timer, see “Personalisation”). €¢ The water inlet hose is not connected to the tap. [. . . ]