User manual DANBY DAC5020

[. . . ] If properly maintained, your air conditioner will give you many years of trouble free operation. To avoid installation difficulties, read these instructions completely before installing/operating your unit. NOTE: This unit is NOT designed for through-the-wall installation. For easy reference, you may want to attach a copy of your sales receipt to this page. [. . . ] This room air conditioner is designed to fit easily into a single or double hung window. However, since window designs vary, it may be necessary to make some modifications for safe, proper installation. Make sure window and frame are structurally sound and free from dry and rotted wood. For maximum efficiency, install the air conditioner on a side of a house or building which favors more shade than sunlight. If the unit is in direct sunlight, it is advisable to provide an awning over the unit. Provide sufficient clearance around the cabinet to allow for ample air circulation through the unit. The rear of the unit should be outdoors and not in a garage nor inside a building. Keep unit as far away as possible from obstacles/obstructions and at least 30" (76. 2 cm) above the floor or ground. Curtains and other objects within a room should be prevented from blocking the air flow. Be certain the proper electrical outlet is within reach of the installation. Use only a single outlet circuit rated at 15 amps. Therefore, it may be necessary to modify or improvise your particular installation. Key Pad Features LED DISPLAY: Displays the following information independently; Set Temperature, Ambient Room Temperature and Auto Timer On/Off settings. POWER: Turns unit On / Off. MODE LED DISPLAY Temp/Timer Control 68 Auto Timer MODE: Allows you to scroll through and select the desired operating mode; Cool , Dry , Fan Only and *Auto Auto . The selected mode will be denoted by the adjacent indicator light. *`Auto' is a pre-set factory program that automatically defines the mode (Cool or Dry) and fan speed based on the set temperature. FAN SPEED: Select from four different fan settings; Check Filter Sleep Mode Auto Auto Low , Medium , High and Auto Auto during Cool and Fan Only mode. Please note: During `Dry' mode the fan speed is automatically defined . ENERGY SAVER: Automatically cycles the fan on and off while the compressor is not in use. /TIMER Control: Used to increase or decrease the Temperature setting in 1°C / °F increments. and Auto-Timer On/Off settings in 30 min. /1hr. increments. MODE Mode Selector Fan Speed Energy Saver Power Button AUTO-TIMER: Used to Initiate the Auto On and/or Auto Off timer. While the Air Conditioner is off (Auto-On): 1. Press the Auto-Timer button once and the adjacent Auto-On indicator light ` ` will illuminate. Use the Temp/Timer control cursors to select a delayed On time of up to 24 hours. [. . . ] Batteries should be replaced when: a) No signal (beep) is heard when attempting to program the main unit. b) The main unit does not respond to a command issued by the remote control. It is recommended that installtion or removal of the airconditioner is done with assitance to prevent injury to persons or damage to the unit or property. IMPORTANT DO NOT forget to install the air filter. If the air conditioner is left to operate without the air filter, dust is not removed from the room air and may result in machine failure. [. . . ]