User manual DANBY DCF (ALL)

[. . . ] We're proud of our quality products and we believe in dependable service. You'll see it in this easy-to-use manual and you'll hear it in the friendly voices of our consumer service department. Tel:1-800-26Best of all, you'll experience these values each time you use your Simplicity Home Comfort Center. That's important, because your new appliance will be part of your family for a long time. [. . . ] If the outlet is a standard 2prong wall outlet, it is your personal responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. Therefore, this information and these specifications are subject to change without notice. Power Indicator light: Solid light signifies that Fan Speed Icons: Shows which fan speed is in Warning Indicator: Illuminates when the unit Used to adjust Humidity settings forward (5% increments). Shows current room humidity and/or temperature conditions. Also displays error codes when the unit enters a fault mode. Auto- Timer Displays time remaining until the unit 8. 8 h automatically powers off or on to a specified setting (see below for details). Each subsequent depression of the Timer button with increase the timer length in increments or 0. The Auto-Timer setting may be cancelled at any time by pressing the remote control Power button. While the appliance is off (Auto-On): Select the appropriate mode under which you want the unit to operate (HumidifyDehumidify or Air Purification) 4. The Timer may be cancelled at any time by turning the unit On/Off. The following steps are provided assuming the unit is in standby mode. 2) Slowly fill the internal water reservoir with fresh clean water until the Water Level Display illuminates all four status bars to signify the tank is full (as shown in Fig G). 3) Replace the fill cap and close the upper rear panel. If you have removed the water tank during the fill process ensure that the handle on the internal reservoir has been returned to it's original position - flat against the bucket. 4) Depress the `Mode' button on the control panel until the Humidifier icon is displayed in the LCD screen (Fig H). 5) Select the desired humidity level from 35% RH ~ 80% RH by depressing either the increase ( ) or decrease ( )buttons on the control panel. To select continuous as the mode of operation in lieu of defining a precise humidity level, press the increase or decrease button until see the " - - " in the set humidity display portion of the LCD, as shown in Fig. 6) Depress the power button to start the unit in Humidifier mode at your specified settings. The Air Purification mode is used to increase air quality by reducing common household odors and allergens such as pollen, pet dander and dust. Air purification can operate individually or in conjunction with either the Dehumidifying or Humidifying modes. 2) When required, you can operate the Air Purification mode simultaneously with the Dehumidifier or Humidifier by continually pressing the MODE button until the required combination of operating mode icons appear in the LCD display. [. . . ] Replace the Air Purification filter only with one that was specifically designed for use with this appliance. Replacement filters are available from the retailer that the unit was purchased from, as well as any Danby authorized parts distibution center. Please call 1-800-263-2629 or visit www. Removal and Cleaning of the Air Filters If the air filters become clogged with dust/dirt, air flow is restricted and reduces performance (efficiency). [. . . ]