User manual DANBY DCR412BL

[. . . ] Conformity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Saving energy. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General safety information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Controls and displays. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Close the vacated retaining hole using the stopper (60). * 3. 2 Temperature display* The following are displayed in normal operation: - the set cooling temperature 4 Putting into operation 4. 1 Transporting the appliance CAUTION Risk of injury and danger of damage as a result of incorrect transport!u Transport the appliance in a packed condition. u Do not transport the appliance without assistance. u Dispose of packaging material (see 4. 3) . * NOTICE* Risk of damage due to condensate!If your appliance is not a Side-by-Side (SBS) appliance: u do not install the appliance directly alongside a further refrigerator/freezer. If the appliance is installed in a very damp environment, condensate may form on the outside of the appliance. u Always see to good ventilation at the installation site. 4. 2 Installing the appliance In the event that the appliance is damaged, contact the supplier immediately before connecting to the mains. The floor at the site must be flat and level. Do not install the appliance in a location where it is exposed to direct radiation of the sun, next to a cooker, heater and similar. Do not install the appliance without assistance. Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m2 per 8 g of R 600a refrigerant used in the appliance. If the room in which the appliance is installed is too small, a flammable gas-air mixture may form in the event of a leakage in the refrigeration circuit. The noise of the refrigeration unit may be temporarily louder as a result. The SuperCool function uses slightly more energy. Cooling with SuperCool u Briefly press SuperCool button Fig. w The cooling temperature drops to the coldest value. w SuperCool is automatically deactivated after 6 to12 hours The appliance continues to operate in the energy-saving, normal mode. It switches on automatically when the compressor runs. To switch off the fan* u Briefly press the fan button Fig. w The fan is switched off. The forced-air cooling is to be recommended: 5 Control 5. 1. 5 Relocating the shelves The shelves have stops preventing them from being unintentionally pulled out. u Lift the shelf and draw it out forwards. u Remove the bottle holder according to the illustration. u Always take hold of the bottle holder on the plastic part. * * 5. 1. 9 Vegetable bins* u Insert shelf with the raised edge pointing upwards at the back. [. . . ] Pay attention that the seal is seated properly in the lamp socket. u Clip the back end of the cover in Fig. 6 and clip the sides into place. The compressor switches to a low speed when little cold is The compressor runs for a long time. 6. 4 Customer service First check whether you can correct the fault yourself by reference to the list (see Malfunction). If this is not the case, please contact the customer service whose address is given in the enclosed customer service list. The noise is produced whenever the refrigeration unit u The sound is normal. (motor) automatically switches on or off. [. . . ]