User manual DANBY DDR401

[. . . ] Do NOT insert anything between the air flow blades, as the inner fan may be damaged and you may be hurt. Particularly, keep children away from the indoor unit. Do NOT place any obstacles in front of the outdoor unit. If the remote control will not be used for a long time, remove the batteries. [. . . ] To do so, press the button, using a small pointed tool (ball-point pen for example). Result: x The AM or PM indication stops flashing. x The clock starts. E-8 Selecting the Automatic Operating Mode You can start the air conditioner in Automatic mode from your remote control. In the Automatic mode, the standard temperature and the optimum fan speed is selected automatically. You can adjust the standard temperature but not the fan speed. 1 If necessary, press the Result: (On/Off) button. x The OPERATION indicator on the indoor unit comes on. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after a three-minute. MODE TURBO OFF IM IMPORTANT 2 If the indication is not displayed at the top of the remote control, press the MODE button on the remote control one or more times until it appears. Result: Note x The indoor unit beeps each time you press MODE . x The air conditioner starts up in AUTO mode. You can change modes at any time. MODE TURBO OFF 3 To adjust the standard temperature (The air conditioner automatically set the standard temperature by the current room temperature. ), press the or buttons one or more times. 1 If necessary, press the Result: (On/Off) button. MODE TURBO OFF x The OPERATION indicator on the indoor unit comes on. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after a three-minute. IM IMPORTANT 2 If the indication is not displayed at the top of the remote control, press the MODE button on the remote control one or more times until it appears. x The indoor unit beeps each time you press x The air conditioner starts up in Dry mode. Result: The blade move up and down, around the base position set. To stop the blade moving up and down, press the button again. 3 Note If you switch the air conditioner. . . Reset to the position that you previously selected. Adjusting the Air Flow Direction Horizontally There are two sets of inner air flow blades. Just as the outer air flow blade can be adjusted vertically, the inner blades can be adjusted horizontally. 1 Open the air flow blade along the bottom of the indoor unit, by pressing the button. To stop the blade moving up and down, press the button again. 2 3 Adjust each set of inner blades to the required position, by pushing or pulling them sideways. E-14 Switching the Unit On and Off Automatically (On/Off Timer) You can set the timer to switch the air conditioner on and/or off automatically at given times. Example: You wish to start cooling your room before you return from work; you decide to: x Switch the air conditioner on at 5:30 p. m. [. . . ] 18°C to 32°C approx. Indoor Humidity 80% or less - If the cooling operation is used at over 33°C (indoor temperature) then, does not a full capacity. E-18 Cleaning Your Air Conditioner To get the best possible use out of your air conditioner, you must clean it regularly to remove the dust that accumulates on the air filter. IM IMPORTANT 1 Before cleaning your air conditioner, ensure that you have switched off the breaker used for the unit. Open the front grille by pulling on the tabs on the lower right and left sides of the indoor unit. 2 Lift out the bottom edge of the air filters and pull down to release them. 3 Remove all dust on the air filters with a vacuum cleaner or brush. 4 When you have finished, insert the top part of the filters into their slot and push down on the bottom edge until they click into place. Front grille 5 Clean the front panel with a damp cloth and mild detergent (do NOT use benzene, solvents or other chemicals). Hook Note x If you have not used the air conditioner for a long period of time, set the fan going for three to four hours to dry the inside of the air conditioner thoroughly. x The removal of the front grille facilitates your cleaning the air conditioner. After opening the front grille, lift up to the max, push slightly to the left, and pull down to release them and vice versa. Body groove E-19 Solving Common Problems Before contacting the after-sales service, perform the following simple checks. They may save you the time and expense of an unnecessary call. [. . . ]