User manual DANBY DFF1708W

[. . . ] You will find your model number on the left hand side wall of the refrigerator. Model # Serial # 2_ features safety information safEty inforMation WARNING · Before operating the appliance, please read this manual thoroughly and retain it for your reference. · Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual. WARNING CAUTION/WARNING SYMBOLS USED Indicates that a danger of death or serious injury exists. WARNING Indicates that a risk of personal injury or material damage exists. CAUTION OTHER SYMBOLS USED Represents something you must NOT do. Represents something you must NOT disassemble. Represents something you must NOT touch. [. . . ] If your model contains wine shelf, you should remove the wine shelf before installing water filters. separation of red cap 1 2 3 sticker (Month indication) Cover filter align the indication mark with lock position setting up _19 instaLLing tHE watEr DisPEnsEr LinE ForExteriormodel Parts for water line Installation Waterlinefixerand screws pipe connector Waterline purifierlock-clip purifier Connecting to the water supply line Connect the water pipe with coupler and tap. Connect coupler "A" to the tap. WARRANTY INFORMATION This water line installation is not covered by the refrigerator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage. CAUTION The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction. COUPLER "A" Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings. TAP LINE OUTLET select the location where the purifier is to install. (Model with the purifier) SIDE OF PURIFIER 90 degree CAUTION - If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration. - Cut the water line attached to the purifier to the appropriate place after measuring the distance WATER INLET SIDE OF PURIFIER between the purifier and the cold water tap. PURIFIER WATER Insert Locking Clip After tube seated COUPLER Locking Clip Replacement Instructions FLOW DIRECTION PERMEAT WATER SUPPLY 1. Insert water supply tube into the inlet side of the filter until the tube stop. Note: ou must also ensure that the cut is square and not at Y any sort of angle as this could cause a leak 4. After inserting tube, put together the clip strongly. If leaks persist, discontinue use and call your supporting dealer. Flush filter for 5 minutes before use. 20_ setting up setting up your side-by-side refrigerator Remove any residual matter inside the purifier. (Model with the purifier) - Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier. Place the refrigerator in an appropriate location with reasonable clearance between the wall and the refrigerator. Refer to installation instructions in this manual. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors. Set the temperature control to the coldest temperature and wait for an hour. The freezer should get slightly chilled and the motor should run smoothly. After powering the refrigerator, it will take a few hours to reach the appropriate temperature. Once the refrigerator temperature is sufficiently cool, you can store food and drink in the refrigerator. using tHE anti-swEat HEatEr switCH When the humidity of the indoor is high, sweat may form around the beverage station & dispenser. Turn the Anti-sweat heater switch on, to remove the sweat and turn the switch off when the sweat disappears. RS21/23H** (OPTIONAL) operating _23 oPErating tHE rEfrigErator USINg THE CONTROL PANEL rs21H K/J, rs23H K/J 1 2 3 4 rs21H f/D, rs23H f/D 5 6 7 rs21H n/B, rs23H n/B 1 poWERFREEZE BUTTON FREEZERBUTToN ICETYpEBUTToN FILTERCHaNgE BUTTON poWERCooL BUTTON CHILDLoCK FUNCTION FRIDgEBUTToN Speeds up the time needed to freeze products in the freezer. This can be helpful if you need to quickly freeze items that spoil easily or if the temperature in the freezer has warmed dramatically (For example, if the door was left open). Press the Freezer button to set the freezer to your desired temperature, You can set the temperature between -14°C (8°F) and -25ºC (-14°F). Use this button to choose Cubed, Crushed or to turn the Ice feature off. [. . . ] This is normal and occurs because various accessories are contracting or expanding in relation to the temperature of the refrigerator interior. the food in the fridge is frozen. you hear unusual noises or sounds. the front corners and · Some heat is normal as anti-condensators are installed in the front corners of the sides of the appliance are refrigerator to prevent condensation. hot and condensation is · Is the refrigerator door ajar?Condensation can occur when you leave the door occurring. ice is not dispensing. · Did you wait for 12 hours after installation of the water supply line before making ice? [. . . ]