User manual DANBY DGR554LP

[. . . ] Pour effectuer des réparations ou obtenir l'adresse du service après-vente le plus proche, veuillez composer le NUMÉRO SANS FRAIS. Pour effectuer des réparations ou commander des pièces de rechange, veuillez donner les renseignements suivants : · Type de modèle · Numéro du modèle · Description des pièces Para obtener servicio, comuníquese con el establecimiento de servicio más cercano o llame al: Barril refrigerador El número de modelo se encuentra en la placa de serie, ubicada en el tablero posterior de la unidad. Puede comprar todos los repuestos o hacer un pedido especial visitando el establecimiento de servicio más cercano a su domicilio. Llame al TELÉFONO GRATUITO para obtener servicio de mantenimiento o la dirección del establecimiento de servicio más cercano a su domicilio. [. . . ] (use pliers to tighten clamp and assure there are no leaks) 18. Installation of the Beer Line Hose to the Keg Coupler: IMPORTANT NOTICE: The black rubber washer (provided) must be installed inside the wing nut before connecting the beer line to the keg coupler. Remove the black rubber protective cap located on top of the keg coupler and screw the wing nut (with rubber washer) onto the keg coupler. Making the connection between the Keg Coupler and Beer Keg: Before making (opening) connection between the keg coupler and beer keg, make sure the beer tower faucet is in the closed position. (faucet handle straight back) To engage the tank connection, pull the keg coupler handle out and push down until it locks into position. Listen for positive "click" of the pull handle in the final downward position. Opening the CO2 Cylinder Main Valve: Before opening the main valve located on top of the CO2 cylinder. Make sure the "secondary" shut-off valve located on the lower stem pipe of the regulator is in the "closed" position. 11 NOTE: When the secondary valve (handle) is positioned "Horizontal" (east/west) the valve is closed. 1 2 When the secondary valve (handle) is positioned "Vertical" (north/south) the valve is open. To open the main CO2 cylinder valve, (slowly) turn the main valve counter clockwise until fully open. You will notice the needles on both gauges start to climb. · When maximum cooling is achieved, turn back the temperature control knob setting to the 2:00 o'clock position on the graduated blue control dial. 15 · Correct cooling temperature is a key factor to consider in storing and dispensing draught beer. · Optimum temperature for serving draught beer is between 34ºF ~ 38ºF. (1ºC ~ 3ºC) Fig. 15 · To maintain temperatures ranging between 34ºF ~ 38ºF. (1ºC ~ 3ºC) We recommend the thermostat knob be positioned at the "2:00 o'clock" setting on the graduated blue control dial. 15 · To turn off the refrigerator, (no cooling) rotate the control knob to the "0" position. 14 8 HELPFUL HINTS ON CONTROLLING TEMPERATURE Keep a thermometer handy. (adjust temperature control knob accordingly) Periodically monitor temperatures inside your cooler. (adjust as necessary) Keep the refrigerator door closed as much as possible to avoid temperature fluctuations CLEANING AND MAINTENANCE AUTOMATIC DEFROSTING: There is no need to defrost the refrigerator, because ice depositing on the evaporator is defrosted automatically. Ice build-up on the evaporator during compressor operation; will (when the compressor has cycled off) defrost automatically. Defrost water collects inside the drain trough and passes through the drain outlet in the rear wall into a drain pan situated above the compressor, where it evaporates. CLEANING THE APPLIANCE: Always disconnect the power cord before cleaning and/or servicing the appliance. [. . . ] #452. 1C #452. 28 #452. 33 For more details on purchasing any of the above listed accessories, please contact our after sales service department at 1-800-26-DANBY (1-800-263-2629). ADDITIONAL INFORMATION ON CO2 Afully charged (5lb). CO2 cylinder will service (approx. ): Quantity. 20 30 Liter Kegs (1/4 Barrels) 25 20 Liter Kegs (1/6 Barrels) For the location of a CO2 supplier in your area, (re-fills) please look in your "Yellow Page" telephone directory under "OXYGEN" suppliers. 12 LIMITED PRODUCT WARRANTY This quality product is warranted to be free from manufacturer's defects in material and workmanship, provided that the unit is used under the normal operating conditions intended by the manufacturer. This warranty is available only to the person to whom the unit was originally sold by Danby or by an authorized distributor of Danby, and is non-transferable. evaporator door, door rails, covers and trays are warranted for thirty (30) days only from purchase date, with no extensions provided. [. . . ]