User manual DANBY DPAC9006 EFOM

[. . . ] Model · Modèle Modelo OWNER'S MANUAL MANUEL D'UTILISATION Portable 3 Season Home Comfort The model number can be found on the serial plate located on the back panel of the unit. All repair parts available for purchase or special order when you visit your nearest service depot. To request service and/or the location of the service depot nearest you, call the TOLL FREE NUMBER. When requesting service or ordering parts, always provide the following information: · · · · Product Type Model Number Part Number Part Description DPAC9006 For service, contact your nearest service depot or call: MANUAL DEL USUARIO 1-800-26-DANBY y (1-800-263-2629) to recommend a depot in your area. Model · Modèle >> Modelo DPAC9006 CAUTION: Read and follow all safety rules and operating instructions before first use of this product. Pour obtenir le service, consultezvotre centre de service le plus rapproché ou composez le : 1-800-26-DANBYnb (1-800-263-2629) qui vous recommandera un centre régional. [. . . ] 2) Press the MODE key until the DRY symbol (Dehumidifying) appears in the display window. Each depression of the MODE key will advance to a different mode setting (Cool-Dry-Fan). 3) Press the appropriate (TEMP / TIMER ADJ) key to select a (relative humidity) operating setting between 35% ~ 90% RH (adjustable in increments of 5%) For continuous (non-stop) dehumidifer operation press the (TEMP / TIMER ADJ) key pad until the symbol "- - " appears in the display window. NOTE: The compressor will not cycle off during "continuous" mode. The set relative humidity level will flash in the display window for approximately 5 seconds then automatically revert back to display actual room ambient relative humidity conditions. NOTE: The set operating RH level must be programed within the 5 second (flashing) condition. To view the "set" relative humidity program any time, press either of the TEMP/TIMER ADJ buttons. NOTE: There is no fan speed adjustment during dehumidifying mode. (the fan speed is factory set for "low") The blue (RUN) indicator light illuminates indicating dehumidifying mode is operational (there may be a slight delay of 10-30 seconds before the cycle begins, this is normal). IMPORTANT: The relative humidity setting selected should always be set a few degrees lower than the room ambient relative humidity conditions, to ensure normal dehumidifying operation. NOTE: it is not recommended to operate your Dehumidifier, below temperatures of 15. 5°C (60°F), this could result in icing-up conditions of the evaporator coils, and minimize efficiency. 4) During `Dry' mode, the "V" icon will illuminate in the control panel display to signify the solenoid valve is open and condensed water is currently being routed to the internal/external tanks. When the external tank is full, water will backflow into the internal tank. When the internal tank is full, the unit will alarm (beep) for 20 seconds and the Water Full red indicator light will illuminate. At this time dehumidification will stop immediately. However, the fan motor will continue to operate (this is normal). Carefully remove both water tanks from the cabinet, dispose of the water. Replace the water tanks back to their original positions and the Dehumidifying process will automatically resume. It may take 3-5 minutes for the compressor to restart. 5) This unit also has provisions for a continuous "drain" option (for basement applications having a floor drain). The required drain hose extension is not included with this unit. It can be purchased through any local Hardware Store. Drain Hose Specifications: Standard garden hose. [. . . ] Garantie . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 24 25 28 26 41 42 LIMITED AIR CONDITIONER WARRANTY This quality product is warranted to be free from manufacturer's defects in material and workmanship, provided that the unit is used under the normal operating conditions intended by the manufacturer. This warranty is available only to the person to whom the unit was originally sold by Danby or by an authorized distributor of Danby, and is non-transferable. TERMS OF WARRANTY Plastic parts, are warranted for thirty (30) days only from purchase date, with no extensions provided. First 12 Months Additional 48 Months Identification des pièces de l'appareil Lamelles horizontales Évents à oscillation Tableau de commande illuminé Hublot récepteur de la télécommande Poignées (aux deux côtés) Panneau du filtre à air amovible (arrière) To obtain Service During the first twelve (12) months, any electrical parts of this product found to be defective, including any sealed system units, will be repaired or replaced, at warrantor's option, at no charge to the ORIGINAL purchaser. During the next forty-eight (48) months any part of the sealed system found to be defective (consisting of compressor, condenser, evaporator, dryer and all related tubing) will be replaced without charge. [. . . ]