User manual DATATRONICS DA5500 V1.4E

[. . . ] Verbatim, TDK, Sony, Samsung, Ricoh, Maxell, etc. , and make sure to reserve some discs for possible troubleshooting tool in the future. For your own safety and the drive protection as well, do not use any damaged disc in order to prevent any accident. Under any circumstance, we do not encourage users duplicate copy protected materials. 3 Main Functions 3. 1 Copy 1. COPY READ MASTER DISC Always make sure that the Master disc is inside the reader, then place blank discs into the Input bin, " [COPY] SPEED MAX Press "Enter" [SPEED MAX] COPY NO. [. . . ] If any of these items are damaged or missing, please contact your dealer directly. 6 DA5500 Series Automatic Disc Duplicator User's Guide V 1. 4E 4. 3 Setting up Please follow the procedures: A. Install the whole Output bin. 4. 4 Loading Discs Wear lint free gloves whenever you handle discs to avoid fingerprints that can affect recording. Make sure the first 5 discs have to be leveled while inserted. You can add discs to the input bin while the system is running. (Capacity: 100pcs) 4. 5 Unloading Accepted Discs It is the responsibility of the operator to keep passed discs away from "rejected" discs. 4. 6 Unloading Rejected Discs It is the responsibility of the operator to keep rejected discs away from accepted discs and master disc. 7 DA5500 Series Automatic Disc Duplicator User's Guide V 1. 4E 5 Maintenance: 5. 1 General Maintenance If you need to clean the outside cabinet and plastic panels, always turn off the AC power switch first and make sure your masters and blanks are covered. Please use a clean lint free cloth moistened with warm water and dry the unit immediately with a clean lint free cloth. 6 Trouble Shooting 6. 1 Frequently asked questions What is the best speed to duplicate audio?If you duplicate audio in max speed, there is a great possibility of failure. Always make sure that master and blank discs are in good condition. If the failure rate is still high, please lower the write speed. Just carefully remove the disc from loader or tray and reload the master and blank discs, then press key to start the job. In order to prevent such problem from happening again, please choose quality discs between 119. 85mm ~ 120. 30 mm and follow the instruction of 4. 4. Sometimes when discs are sticky, which is commonly seen on the plastic wrapped bulk discs, it is more difficult to remove disc from each other, therefore, we suggest you loosen discs completely before loading. Why is that the power switch does not work every time?This can be easily solved if you allow 5 seconds interval between turn on/off. Why is that the Robotics arm fails to pick up the discs?If the robotics arm is still in the accurate position as it should be, which means no force has been pressed upon it to cause dislocation, check if discs are the right size and not distorted in any form. Normally if robotics arm is having mechanical problems, it will not pick up any disc at all. So to determine the cause you might use other discs to see if it works. If none of the above is the reason, you have to check the burner position and the length of tray when it reaches out. Please contact your dealer for assistance. What should I do if 2 or more discs drop at the same time? [. . . ] ERROR CODE 6 ----> Job completes, but robotics arm does not sense the disc in the tray. ERROR CODE 7 ----> Job fails, and robotics arm does not sense the disc in the tray. Reboot the unit please. 9 DA5500 Series Automatic Disc Duplicator User's Guide V 1. 4E 6. 4 And More: When turn on the unit, if disc is detected in the writer, arm will pick it up and remove to reject bin. If DVD disc is dropped in the writer, LCD will show NO DISC, and arm will not pick it up. [. . . ]