User manual DAXTEN SCOUT 8 BROCHURE

[. . . ] Optional PS/2 to USB adaptor for USB Computers (2141-01U) Hardware Installation Installation 1. Before connecting your computers and console devices to the SCOUT switch, please ensure that all devices are powered off. Connecting devices while powered on may lead to damage to your computers or the SCOUT switch. Daxten cannot be held responsible for damage caused by connecting devices that are powered. [. . . ] Press any key to exit the Auto-Scan mode. The SCOUT switch will stop at the last PC shown Selection buttons Pressing the individual PC buttons on the front of the SCOUT will switch the signal to the desired computer. OSD (On-Screen-Display) To access the OSD, press the Hot Key Scroll Lock Scroll Lock Space Bar. OSD (On Screen Display) is a menu that is superimposed on your screen. On the OSD Menu, you will have a listing of the available units (banks) and channels for selection and the currently online status of each channel. You can use it to control the SCOUT Switch with more convenient and intuitive menu-driven operation. The OSD menu also allows you to rename your computer (up to 9 characters), and to find the specific computer by its name. It also allows you to password-protect your SCOUT Switch system. Use the left, right, up, down cursor keys to navigate. Use Enter / Insert key to select and edit. Change PC name Navigate to the PC Name you want to change, and then press Enter or Insert key for editing a new PC name. When done, press Enter to validate the new name. Figure 1 ­ OSD Display Autoscan Delay Time Use cursor keys to navigate to the SCAN option on the OSD Menu, and then hit Enter to select and edit the auto scan delay time. The Autoscan Delay Time is default to 10 seconds. The autoscan delay time could be specified within the range of 5 seconds to 99 seconds by an increment of 1 second. Users can adjust the scan delay time according to their needs. OSD Remain Time Use cursor keys to navigate to the OSD option on the OSD Menu, and then hit Enter to select and edit the OSD Remain time. The OSD Remain Time is defaulted to 10 seconds. The OSD time can be specified within the range of 5 seconds to 99 seconds in increments of 1 second. You can adjust this parameter to your needs. Password Configuration Navigate with cursor keys downwards to the PWD CONFIG option and then hit Enter key or Insert key to select. Follow the submenu to Enable or Disable the Password Protection. Every time you want to change the password configuration, you will be prompted for the password. You have to type in the correct password to validate the change. The password can be up to 8 characters long and defaults to 00000000. You can change the default password with your own password with the PWD CHANGE option. [. . . ] If non-Daxten approved power supply or cabling is attached to the product. If defect or malfunction was caused by abuse, mishandling, unauthorized repair, or use other than intended. If unauthorized modifications were made to product. If unreported damages occurred in any shipment of the product. [. . . ]