User manual DAXTEN VOYAGER 300

[. . . ] Switch the computer off before wiring up the units. Hardware Installation Before connecting your computer to the Voyager Local unit, please ensure that it is powered off. Connect your console devices to the Voyager remote unit. Note: the Voyager Remote requires power. If your computer does not have a PS/2 mouse or keyboard port, you can use a PS/2 to USB converter (2141-01U). [. . . ] Orientation: Looking into the RJ45 socket pin 1 is on the left and Pin 8 on the right. Pin 1 2 3 4 5 6 7 8 Wire Colour White/Orange Orange/White White/Green Blue/White White/Blue Green/White White/Brown Brown/White Wire T2 R2 T3 R1 T1 R3 T4 R4 Pair 2 2 3 1 1 3 4 4 The Voyager has been tested with all major makes of CAT 5 cable including BICC-VERO, Mohawk, and Brand-Rex. The Voyager has also been tested with most major makes of CAT 5E and CAT6 with good results. Note: That failure to wire the twisted pairs correctly will impair the video quality dramatically and / or prevent correct operation. This Voyager 300 extender is designed for use up to a maximum cable length of 350m/1200ft. resolution should be at 1600 x 1200 @ 85Hz. At a length of 300m the video quality should still be acceptable even at a screen resolution of 1024 x 768 (85Hz). With cable distances of 300m and over you may require a skew compensator (1024-00SE) this will depend on the quality of your CAT 5 or CAT 6 cable and or monitor resolution. Although a single continuous length of interconnect cable is preferable, operation is possible through multiple Patch Panels. However, the more patch panels the cable is routed through, the greater the chance of video signal degradation. Quick Setup System Guide Connecting Up 1. Connect the Voyager Local Unit to the PC KVM Cable Plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard, Monitor and Mouse ports on the Voyager Local Unit. (You can use the Voyager without having a Local Keyboard, Monitor and Mouse connected). Connect your UTP cable to the Voyager Local Unit. Connect the PC KVM cable to your computer's Keyboard Monitor and Mouse ports. Connect the other end of your UTP cable to the Voyager Remote Unit. Connect the power supply unit to the Voyager Remote unit. Plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard, Monitor and Mouse ports on the Voyager Remote Unit. Check that the keyboard and mouse operate correctly. Adjust the Video Equalisation if required on the Voyager Remote Unit which contains video equalisation circuitry that will compensate for the loss in image quality experienced when sending video over long cables. . Front Panel Layout Voyager 300 Remote Unit To set the correct level of equalisation there are two adjustments on the front panel of the Voyager Remote Unit. Adjust the Distance to the appropriate cable length, and then adjust the Eq to fine tune the setting (these only need to be set once. ) LED No Light Led 1 On Led 2 On Cable Length 0 ­ 100 m 0 ­ 350 ft 80 ­ 220 m 250 ­ 725 ft 190 ­ 350 m 600 ­ 1200 ft The remote unit (when installed in its final location) may be left permanently powered up. In order to make the distance settings as easy as possible, the Voyager 300 incorporates three boost steps, which means there will be a big gain jump when the LED's change. Note: Always try the EQ adjustment before and after the LED's change, to achieve the best picture quality. [. . . ] If the product is used with non-grounded or incorrectly polarized AC power. If the product is used in contradiction to any instruction provided by any User Guide or Instruction Sheet provided to you or with the product. EXCEPT AS SPECIFICALLY PROVIDED ABOVE AND TO THE MAXIMUM EXTENT ALLOWED BY LAW, DAXTEN DISCLAIMS ALL WARRANTIES AND CONDITIONS WHETHER EXPRESS, IMPLIED, OR STATUTORY AS TO ANY MATTER WHATSOEVER INCLUDING, WITHOUT LIMITATION, TITLE, NON-INFRINGEMENT, CONDITION, MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR OR INTENDED PURPOSE. EXCEPT AS EXPRESSLY PROVIDED ABOVE AND TO THE MAXIMUM EXTENT ALLOWED BY LAW, DAXTEN SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT OR CONSEQUENTIAL DAMAGES (INCLUDING WITHOUT LIMITATION, LOSS OF PROFIT, LOSS OF BUSINESS, LOSS OF INFORMATION, FINANCIAL LOSS, PERSONAL INJURY, LOSS OF PRIVACY OR NEGLIGENCE) WHICH MAY BE CAUSED BY OR RELATED TO, DIRECTLY OR INDIRECTLY, THE USE OF A PRODUCT OR SERVICE, THE INABILITY TO USE A PRODUCT OR SERVICE, INADEQUACY OF A PRODUCT OR SERVICE FOR ANY PURPOSE OR USE THEREOF OR BY ANY DEFECT OR DEFICIENCY THEREIN EVEN IF DAXTEN OR AN AUTHORIZED DAXTEN DEALER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSSES. Waste Electrical and Electronic Equipment (WEEE) Within the European this symbol indicates that this product should not be disposed in household waste. [. . . ]