User manual DAXTEN VOYAGER DVI EXTENDER

[. . . ] This product will allow you to place your Monitor with a Digital Video Interface, your Keyboard and Mouse up to 150 meters (dependant on cable type) away from your computer. Product Features Support for DVI-D Graphic cards (all devices) Support for PS2 Keyboards and Mice or USB Keyboard and Mice, depending on version Maximum resolution: DVI-D: 1600x1200@60Hz Supporting 18 Bit color depth = 256, 000 colors Status indicator LEDs on each device Small footprint chassis Rack mount options available CPU cables and Adapters included Preparing installation For first-time users, we recommend that you carry out a test placement, confined to a single room, before commencing full installation. This will allow you to identify and solve any cabling problems, and experiment with the Voyager DVI extender. Hardware Installation Connecting Up 1. Connect the Voyager Local Unit to the PC KVM Cable Connect the USB cable from the Local unit to the PC (USB versions only) On a dual system plug in your Keyboard, Monitor and Mouse into the corresponding Keyboard / Monitor via the supplied adaptor (PS/2 Keyboard and mice). The keyboard can be plugged in directly to the unit if required. [. . . ] The Local and Remote Units are connected by industry standard structured cabling (Category 5, 5E or 6 UTP/STP, 4-pair) terminated with RJ45 connectors. The cable used should be solid trunk cable. Stranded patch cable will give poor results over longer distances. The connector wiring must meet the EIA/TIA 568 standard. CAT5 Wiring Scheme The Local-Remote interconnection cable is terminated in RJ45 connectors and should be wired according to the EIA/TIA 568 (Scheme B preferred) industry standard. The Voyager will function with other wiring schemes, but the video quality may be impaired. Orientation: Looking into the RJ45 socket pin 1 is on the left and pin 8 on the right. Pin 1 2 3 4 5 6 7 8 Wire Colour White/Orange Orange/White White/Green Blue/White White/Blue Green/White White/Brown Brown/White Wire T2 R2 T3 R1 T1 R3 T4 R4 Pair 2 2 3 1 1 3 4 4 The Voyager has been tested with all major makes of CAT 5 cable including BICC-VERO, Mohawk, and Brand-Rex. The Voyager has also been tested with most major makes of CAT 5E and CAT6 with good results. Note: That failure to wire the twisted pairs correctly will impair the video quality dramatically and / or prevent correct operation. This Voyager DVI extender is designed for use up to a maximum cable length of 150m / 500ft At this length the video quality should still be acceptable even at a screen resolution of 1600 x 1200 (60 Hz). Although a single continuous length of interconnect cable is preferable, operation is possible through multiple Patch Panels. However, the more patch panels the cable is routed through, the greater the chance of video signal degradation. Diagnostic LEDs on the Voyager DVI LED Power LED (Red) Video LED (Green) Link Status (Green) (Right LED on RJ45 connector) Data Status (Green) (Left LED on RJ45 connector) Appearance Off On Off On Blinking On Blinking / On Off Diagnostics Device not ready Device Ready No Signal or Invalid Signal Device Ready No CAT5 Connection Device Ready Data Error ­ Cable to long or too much interference etc. Device Ready Quick Setup System Guide Front & Rear Panel Layout Voyager DVI Single head PS/2 ­ Local Unit Front & Rear Panel Layout Voyager DVI Dual head USB ­ Local Unit Front & Rear Panel Layout Voyager DVI Single head USB ­ Remote Unit Front & Rear Panel Layout Voyager DVI Dual head PS/2 ­ Remote Unit Note: The Voyager DVI USB only supports USB Keyboards and Mice. Other HID types (Human Interface Device) are not supported, even though some Touch Screens, Graphic Tablets, Barcode readers or similar devices may work, this cannot be guaranteed. The Voyager DVI USB is not suitable for Web Cams, scanners, hard drives etc. Service Information Technical Support If you cannot determine the nature of a problem, please call Daxten and ask for Technical Support. If possible, call from a phone located near the unit, as we may be able to solve your problem directly over the phone. If we cannot solve your problem, and determine that the fault is in the unit, we will issue a Return Material Authorisation (RMA) number that must appear on the outside of all returned products. The unit should be double-packed in the original container, insured, and shipped to the address given to you by our Technical Support representative. The Technical Support offices are found on the back of this manual. Limited Warranty Daxten warrants to the end user that this product is and will be free from defects in materials and workmanship for a period of 24 months from the date of purchase. If during the warranty period the product should fail, the purchaser must promptly call Daxten for a RETURN MATERIALS AUTHORIZATION (RMA) number. [. . . ] It should be deposited at an appropriate facility to enable recovery and recycling. For information on how to recycle this product, please check with the reseller of the product that replaces this product "Take Back" or the original seller of this product. www. daxten. com Ireland Bay 21 Free Zone West Shannon, Co. Clare info. ie@daxten. com www. daxten. ie Tel: +353 (0) 61 23 4000 Fax: +353 (0) 61 23 4099 USA 811 W. Evergreen Ave Suite 302A Chicago, IL 60622 info. us@daxten. com www. daxten. us Tel: +1 312 475 0795 Fax: +1 312 475 0797 United Kingdom 5 Manhattan Business Park Westgate London W5 1UP info. uk@daxten. com www. daxten. co. uk Tel: +44 (0) 20 8991 6200 Fax: +44 (0) 20 8991 6299 · Österreich Künstlergasse 11/4 A-1150 Wien info. at@daxten. com www. daxten. at Tel: +43 (0)1 879 77 65 Fax: +43 (0)1 879 77 65 30 · Deutschland Salzufer 16, Geb. [. . . ]