User manual DAXTEN VOYAGER UTP EXTENDER BROCHURE

[. . . ] Voyager UTP Extender Serial Addendum Voyager UTP Extender Serial Addendum The default settings for serial extension (9600bps, 8 data bits, no parity, 1 stop bit, RTS/CTS and DTR/DSR loopback) should be suitable for the majority of applications. This addendum describes how you can adjust the baud rate and hardware flow control for specialist applications. Serial Interface Setup and Operation You can configure the baud rate and flow control protocol using jumpers on the serial daughter board (see Figure 1) in the Remote and/or Local units. [. . . ] Use this procedure if you want to change the baud rate. Locate the Baud Rate jumper block in the Remote unit. Set the jumper to the required setting as shown in Figure 2. 9600 19200 Figure 2 Remote Unit Baud Rate. Ensure that the jumpers are set correctly on both the Voyager UTP Local & Remote units Changing the Baud Rate on the Voyager UTP Local Unit All Local units are supplied with the baud rate preset at 9600/19200. Use this procedure if you want to change the baud rate. Locate the Baud Rate jumper block in the Local unit. Place the jumper over the posts as shown in Figure 3. 9600 / 19200 1200 Figure 3 Local Unit Baud Rate. 3. Set the hardware flow control jumpers in both Local and Remote Units to RTS/CTS Flow Control across CAT5 Link as described below. Ensure that the jumpers are set correctly on both the Voyager UTP Local & Remote units This mode will support most, but not all, serial mice and trackball devices. In most cases, we recommend that you use PS/2 mouse devices with the Voyager UTP extender. If your have a PC that does not have a PS/2 mouse port, then use a PS/2 Mouse on the remote unit and use a PS/2 to Serial mouse converter (2146-00C) on the Voyager Local Unit to connect to the PC Note: The drivers supplied with certain Wacom Graphics Tablets dynamically alter the baud rate and cannot be used with a Voyager UTP Extender system. There is a version of the driver available with a fixed baud rate. [. . . ] B 10587 Berlin info. de@daxten. com www. daxten. de Tel: +49 (0) 30 8595 37-0 Fax: +49 (0) 30 8595 37-99 · Schweiz Seebahnstr. 231 8004 Zürich info. ch@daxten. com www. daxten. ch Tel: +41 (0) 43 243 32 11 Fax: +41 (0) 43 243 32 16 · España C/Florian Rey, 8 50002 Zaragoza info. es@daxten. com www. daxten. com. es Tel: +34 902 197 662 Fax: +34 976 201 633 · Sweden info. se@daxten. com www. daxten. se · France B. P 04 - 77 Route de Cheptainville 91630 Marolles-en-Hurepoix info. fr@daxten. com www. daxten. fr Tel: +33 (0)1 64 56 09 33 Fax: +33 (0)1 69 14 88 34 · Denmark info. dk@daxten. com www. daxten. dk · · · [. . . ]