User manual DE DIETRICH DFS511JE1

[. . . ] They contain important information for safe use, for installation and for care of the appliance. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and / or with signal words ( Warning!, Caution!, Important!). This symbol and numbered instructions guide you step by step in the operation of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. The operating instructions contain instructions for the correction of possible malfunctions by the user in the section" What to do if . . . ". [. . . ] In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used. Should the plug need to be replaced for any reason. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow: Earth Blue: Neutral Brown: Live The wire coloured green and yellow must be connected to the terminal marked with the letter "E" or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal "N" or coloured black. The wire coloured brown must be connected to the terminal marked "L" or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. sounds and the alarm signal lamp flashes. The acoustic alarm signal sound and the red alarm signal lights up: Press the button to stop the acoustic alarm signal. The red alarm lamp continues to flash until the freezer reaches the proper temperature. on putting the equipment into service until the temperature necessary for safe food storage is maintained. after loading fresh food in a quantity exceeding the freezing capacity (see "Freezing") if the lid remains open for long time. If there is a malfunction and the internol temperature cannot be maintained. The acoustic alarm signal fails to sound and the red alarm indicator fails to light up: if the power supply to the equipment fails in the case that the electronic temperature controller has failed. Prior to putting into service Clean the inside of equipment and all the appliances prior to putting into service the first time (see chapter: "Maintenance") Adjusting the temperature setting Use a coin to turn the temperature control knob. 2. Remove mains plug 3. For replacement of the bulb press the cover hook and remove as shown in the illustration 4. Replace defective light bulb. 5. Place the cover again. Packaging and positioning Food must be cold before freezing (no more than room temperature) Food must be packed in airtight and moisture -proof packaging to prevent it from drying out. Place fresh food for freezing close to the cold sides of the freezer, making sure that it is not in contact with frozen food already in the freezer. Never fill the freezer to more than loading line (arrow with dashed line) shown on the illustration. See under "Helpful hints". Load Line Fyldningsniveau Fyllingsniva Niveau de de remplissage Füllhöhe Replacement of electric bulbs Warning!Prior to replacement of electric bulbs, remove the plug from the mains socket or disconnect or unscrew the fuse or lodgement. Capacity Lamp For the removal of the lampshade you have to push the hook by a screwdriver first, and than you can turn it out Lamp specification: 220 to 240 V, max 15W bulb holder: E14 The freezing capacity of the freezer is stated in the data plate (kg/24 hours). Do not exceed the amount stated - if you do, the freezing capacity time will be extended. The data plate is located on the back of the cabinet. 14 electrolux cold Important!The freezing capacity stated can be utilised to the full occasionally to freeze large amounts of fresh food. However, if the freezer is filled with large amounts of food for freezing every day, the capacity stated is reduced by about one-third. Basket The basket is designed for fast freezing and protection for part of the lid (Air inlet). The handles can be placed in one position as shown in the drawings. [. . . ] Never use strong cleaning agents, scouring powder or strongly aromatic cleaning agents to clean your freezer inside, since this will damage the inside and leave a strong smell. electrolux cold 17 If something does not work Check the following before making a request for service: Defect: Freezer not cold enough Possible cause: Action: Plug not connected Check plug and socket correctly Defect in switch or fuse Check fuse, call electrician Power failure Wait until current returns Green and red light on Fresh food recently Wait of couple of hours placed in freezer Air chanel blocked Clean the vented floor Lid open to long Wait of couple of hours Thermostat set too warm Set thermostat colder "Super" function active Press "Super" button out Thermostat set too cold Set thermostat warmer Check if: Green light not on Freezer too cold Green light on, red light not on Yellow light on Yellow light not on If you are still unable to solve the problem, contact your local Service Force Centre. Do not attempt to repair the appliance yourself. Incorrect procedure may cause personal injury or lead to additional defects. If the freezer has been switched off briefly, the compressor may not start immediately when the current is re-connected. [. . . ]