User manual DE DIETRICH DHD1101X

[. . . ] EN The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ] 4) 5) 6) 7) Apply the glue to the lower part of the hood’s edge (Fig. Insert the downdraft inside the furniture from the top. The edge of the hood must be perfectly fixed to the upper surface of the kitchen furniture. Fix the hood inside the furniture utilising the two supplied brackets (fig. 8) Proceed with the assembly of the motor onto the body of the hood orientating the air outlet to the desired higher or lower position (Design 4). The motor can be fitted in the front or rear part of the hood. To install the motor in the rear part, proceed as follows: unscrew the plate situated in the rear part of the hood, screw the motor to the hood in place of the plate, correctly connect the motor cable and screw the plate back onto the front part of the hood. attach the air extractor tube (not supplied). Connect the other end of the tube to the outside of the furniture for a filter installation or to the outside of the habitation for an extractor installation (Fig. Attention: To avoid damaging internal sliding components such as the electrical parts, do not make other holes in the product. 9) Position the metal box containing the electronic components in an easily accessible position for any eventual assistance intervention. connect all electrical connectors to the hood. 10) Connect the hood to the electrical mains circuit. 11) Once the installation has been completed and the hood has been connected to the electrical mains circuit, start the extraction of the carriage (refer to the chapter about how the hood functions) and remove all protective material (Fig. It has been designed e either in the suction or filter versions. The air extractor tubes are not supplied as standard. Version with exterior evacuation The hood is equipped with an air outlet (Refer to the image below). To convey smoke outwards (the flue pipe and fixing flange are not supplied). In filtering application that the stop valve doesn’t permit the entrance of wind and exhausted air. Filtering version In the case an exhausting hole is not possible, the hood can be used in filtering version. For this mode charcol filters are to be fitted inside the hood. Filtered air will be evacuated in the kitchen trough a duct that conveys the air on a side of the cabinet (Fig. [. . . ] ACCESSORY/PRODUCTS TO USE External surfaces and accessories To clean the external surfaces of the Do not use metallic scrubbers, hood and the light housing screen abrasive products, or hard use only commercially available household detergents diluted in wabrushes. Then rinse with clean water and dry with a soft cloth. The grease filters can be washed by hand or in the dishwasher. These filters need to be cleaned on a regular basis because otherwise they may present a fire risk. [. . . ]