User manual DE DIETRICH DHD1129W

[. . . ] 10- If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 12- If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. [. . . ] Before installing the hood it is possible to fit the splashback provided, if required. Mark the holes required to fix it to the wall, as shown in fig. Drill the wall (2 holes Ø 5mm) and insert the wall plugs. Fix the splashback to the wall using the two 3x35 screws (provided). The hood can be supplied with two different fixing kits: a) screws, plugs and safety square. 1 - Fixing with screws Using the cardboard template, mark and drill the holes on the wall (2 holes Ø 8 mm see instructions on the template), insert the plugs in the holes, tighten both 4, 2 x 44, 4 screws(supplied) leaving about 5 mm unscrewed, hook the hood onto the screws (fig. Mount the safety square (supplied) above the hood (fig. 2 - Fixing with brackets Using the cardboard template, mark and drill the holes on the wall (4 holes Ø 8 mm see instructions on the template), fix the metal brackets with screws and plugs (supplied), hook the hood onto the brackets (fig. Fix the hood with two knobs (supplied) (fig. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods. Regular maintenance will ensure good performance and extend the working life of the hood. Special attention should be taken to the grease filters and, for the filter hoods only, to the charcoal filters. 1 - Cleaning These filters need to be washed with ordinary household detergent every 2 months maximum. Thanks to their reduced dimensions, they can also be washed in the dishwasher. Make sure that the filter is dry before replacing it, close the grid panel. 1 - How they work Charcoal filters can absorb smells and odours until they are saturated. [. . . ] Make sure that the filter is dry before replacing it, close the grid panel. 1 - How they work Charcoal filters can absorb smells and odours until they are saturated. They cannot be washed or recycled and so they should be replaced at least every 4 months or more frequently if the hood is heavily used. It is composed of one or two 40 W lamps which can be reached by removing the grid panel (Fig. [. . . ]