User manual DE DIETRICH DHD1187X

[. . . ] Qxp 14/06/2007 13:33 Page 44 FR DE EN ES IT 02 23 Dear Customer, You have just acquired a DE DIETRICH hood and we would like to thank you. 44 65 86 Our research teams have created this new generation of appliances for you. Their quality, design, features and technological advances make them exceptional products, and reveal our unique know-how. Your new DE DIETRICH hood will blend harmoniously into your kitchen and will perfectly combine extraction performance and ease of use. [. . . ] The electrical connections are made before the appliance is installed in its housing. Ensure that: - the electrical installation has sufficient voltage, - the electrical wires are in good condition, - the diameter of the wires complies with the installation requirements. Warning This appliance is delivered with a H 05 VVF power cord that has three 0. 75 mm2 conductors (neutral , phase and ground). It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. The fuse in your set-up must be 10 or 16 amperes. If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. ASSEMBLING THE HOOD Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In France these regulations are described in DTU 61. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. -- Draw a horizontal line 70 cm minimum from the cook top (A/fig. 1) on the wall that is centred over the cook top and that extends from the ceiling to the horizontal line drawn in the previous step (A). 1) on the wall, superimposing the line that represents the hood's axis over vertical line B (fig. 1) flush with the ceiling for support and position the notches over axis B. -- Using the rectangular cut-outs, attach the suction hood to the two brackets (fig. The size of these cut-outs allows you to adjust the position to the right or left. [. . . ] Model with halogen bulb -- Remove the lighting port (fig. -- Replace the bulb by repeating these steps in reverse order. Qxp 14/06/2007 13:34 Page 62 EN 4 / CARING FOR AND CLEANING YOUR APPLIANCE Warning Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. PRODUCTS/ ACCESSORIES TO USE Top surface and accessories Never use metal scouring pads, To clean the body and the lighting abrasive products or excessively port, you should use only stiff brushes. [. . . ]