User manual DE DIETRICH DHD1193W

[. . . ] For wire connectors, use standardized products. 3 Rotate the connected product by 20 degrees. Then insert it into the T-Bar insertion space. • Make sure that all 4 sides of the product match the T-Bar. 4 Place the horizontal product into the T-Bar. 5 Ensure the inserted product is horizontal. ※ During the use of connector socket, if the power line is forced in, it may not be lighted due to defect contact. Turn power off before contact of the product. • Risk of electric shock. Use with proper rated voltage. [. . . ] • Make sure that all 4 sides of the product match the T-Bar. 4 Place the horizontal product into the T-Bar. 5 Ensure the inserted product is horizontal. ※ During the use of connector socket, if the power line is forced in, it may not be lighted due to defect contact. Turn power off before contact of the product. • Risk of electric shock. Use with proper rated voltage. (less than ±10%) • Risk of fire and product damage. -Connector Socket- 6 Perform grounding work. • Risk of electric shock. Electric work must be performed by a certified technician according to the installation manual. • Inadequate power capacity and faulty electric work may lead to fire or electric shock. Do not randomly connect the power polarities. • Risk of product damage and accidents. Once installation is complete, turn on the power switch to check it is operating properly. • After the installation is complete, remove the protective sheet. ※ When this luminaire is connected to branch circuit, installation engineer must use the connector that meets the glow-wire test of 650°C (in case of France, 850°C) or higher. 2. M-BAR • Make sure to turn off the main power switch of the installation space before connection. • Connect so that the colors of the 3 power cables match. (LIVE: BROWN, NEUTRAL: BLUE, P. E. : GREEN/YELLOW) • Use woodscrews provided by DE DIETRICH Electronics. (In case of a model of 620 M-Bar, Use silver colored screws if the ceiling tiles are thicker than 9. 0t. If not, use black colored screws. ) LIVE LIVE LIVE P. E. Check Check to see if the power is connected or if the switch is off. Check to see if the dimming wires has short-circuited. Limited Warranty The limited warranty set forth below is given by DE DIETRICH Electronics, Inc. (“DE DIETRICHE”) with respect to the lighting product packaged with this limited warranty. Your Product , when delivered to you in new condition in its original packaging, is warranted against defects in materials or workmanship as follows: for a period of two (2) years from the date of original purchase, defective parts or a defective Product returned to DE DIETRICHE, or its authorized service providers, as applicable, and proven to be defective upon inspection, will be repaired, or exchanged for a new Product, as determine by DE DIETRICHE, or the authorized service provider. This limited warranty is conditioned upon proper storage, installation, use and maintenance complying with their respective published specifications, and does not apply in the following cases: (a) Loss of or damage to the Product due to abuse, mishandling, alteration, accident, electrical current fluctuations failure to follow operating, maintenance or environmental instructions prescribed by DE DIETRICHE in writing or services performed by someone other than DE DIETRICHE or an authorized service provider. To make a warranty claim, contact your local DE DIETRICHE sales representative. After contacting your local DE DIETRICHE sales representative, you will receive instructions regarding if, when and where to ship non-conforming Product. Failed Product must be returned for inspection and verification of non-conformance by DE DIETRICHE. [. . . ] After contacting your local DE DIETRICHE sales representative, you will receive instructions regarding if, when and where to ship non-conforming Product. Failed Product must be returned for inspection and verification of non-conformance by DE DIETRICHE. Failure to follow this procedure shall void this warranty. [. . . ]