User manual DE DIETRICH DHD365XP1

[. . . ] The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. 5-6-7 Preliminary information for installing the hood Assembling the deflector (Fig. [. . . ] Fix the top flue assembly to the truss, near the ceiling, with two screws (one each side). Carry out electrical connection of control panel and bulbs. Make connections taking care to insert the connectors in the right way. Join the two bottom sections of the flue covering the truss using 6 screws (3 each side, see the plan diagram for joining the two sections). Insert the bottom section of the flue in its seat so that it completely covers the motor compartment and electrical connection box, then ensure it from inside the hood using two screws. Apply the 2 tabs (supplied) to cover the fixing points of the bottom flue (CAUTION!THE BOTTOM FLUE TABS ARE THE NARROWER AND SHALLOWER ONES). The wider and deeper tabs are those used for the top flue, and must be cut to size. Turn the mains power on again at the central electrical panel and check for correct hood operation. Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. GB INSTRUCTION ON MOUNTING AND USE Description of the hood - Fig. 1 1 Control panel 2 Grease filter 3 Grease filter release handle 4 Halogen lamp 5 Vapour screen 6 Telescopic chimney 7 Air outlet (used for filter version only) Operation Model with button panel Description of control panel and hood operation 9 A B C D Charcoal filter (filter version only) It absorbs unpleasant odours caused by cooking. The charcoal filter can be washed once every two months (when using the hood 2, 5 hours per day, in avarage and, for the model with electronic control panel, every time LED 5 starts to flash see preceding page) using hot water and a suitable detergent, or in a dish-washer at 65C (if the dishwasher is used, select the full cycle function and leave dishes out). Eliminate excess water without damaging the filter, then remove the mattress located inside the plastic frame and put it in the oven for 10 minutes at 100 C to dry completely. Replace the mattress every 3 years and when the cloth is damaged. [. . . ] Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply. Cleaning The cooker hood should be cleaned regularly internally and externally. For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]