User manual DE DIETRICH DHG770X

[. . . ] There are no user-serviceable parts inside. Refer servicing to qualified service personnel. To reduce the risk of fire or electric shock, do not expose this product to dripping or splashing water, rain, or moisture. The temperature of unit's outside can be extremely high, please use the unit after proper installation in your vehicle. [. . . ] Push the right side of panel into the unit until it clicks. The control buttons may not work properly if the control panel is not attached properly. If this occurs, gently press the display. Do not leave the control panel in any area exposed to high temperatures or direct sunlight. Do not drop the control panel or otherwise subject it to strong impact. Do not allow such volatile agents as benzine, thinner, or insecticides to come into contact with the surface of the control panel. > Caution 5. Put the detached control panel into the protective case. Control panel Protective Case Connecting 7 Connection Connecting to a car Before installing, make sure that the ignition-switch is set to OFF and remove the terminal of the car battery to avoid short-circuiting. Wired remote input (Black): Hard-wired control adapter can be connected. (Optional) To Audio out (Optional) Rear Left (Sub-woofer Left) Rear Right (Sub-woofer Right) Front Left Front Right Amplifier Power Antenna Control Relay To Audio in (Optional) 2 Connecting abcdabcd efghefgh When being connected in a wrong way, the unit displays as follows. - Antenna / Remote port short: "ANTENNA/ REMOTE ON PORT SHORT CIRCUIT CHECK" After connecting it again, restart the unit. > Caution B f Power Antenna (Blue) B g Not connected B c To Ignition (Red) B d To Battery (+) (Yellow) B h Ground (-) (Black) Ignition Switch A A A B e Remote On (Blue / White) (Optional) B b Not connected a b c A d A e A f A g A h A a Gray : Front Right + A b Gray / Black Stripe: Front Right A c Violet : Rear Right + A d Violet / Black Stripe: Rear Right A e White : Front Left + A f White / Black Stripe: Front Left A g Green : Rear Left + A h Green / Black Stripe: Rear Left - Amplifier B a Not connected 8 Operating Operation Basic operations 1. Turn the unit on by pressing any key on the unit. Rotate the volume knob to adjust the volume on the unit. Or press w / s on the remote control to set the option. Or press ENTER on the remote control to confirm the setting. step, press Or press on the remote control. DIM LV (Dimmer Level) : When you set DIM to ON, you can adjust the dimmer level. (-2, -1, 0, +1, +2) For [OTHER] setting AUX (Auxiliary) ON / OFF It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit. DEMO OFF / ON You can change the initial indication on the display to information name (function name, EQ name, etc. . . ) while listening to a source. BEEP 2ND / ALL BEEP 2ND : The beep is generated when a key is pressed for longer than 2 seconds. BEEP ALL : The beep is generated when any key is pressed. Storing desired frequencies manually 1. Press BAND to select a desired band you want to store. Select the desired frequency by using Y/U on the unit. press the volume knob and rotate the volume knob to select a preset station among 1 to 6 and then press and hold the volume knob until the beep sound is heard. [. . . ] If there is no information, "NO TEXT" will be shown in the display window. Searching for a section within a file 1. Press and hold Y/U on the unit for about 1 second during playback. Or press and hold c / v on remote control. Press T on the unit at the point you want. [. . . ]