User manual DE DIETRICH DOD448BG1

[. . . ] The glass cover (only on some models), before lighting the over burners of the top and until their turning off, shall be in open position; it is important to avoid any contact with cookware during the cooking in order to save from a dangerous overheating. Important After the cooker use it is recommended to: 1) always check that the knobs are in the " " position. 2) close the cock of the gas cylinder (if you use liquefied gas) or the supply cock (in case of natural gas). IMPORTANT: The appliance must be installed only by qualified and competent technicians in compliance with the national provisions in force. [. . . ] oVEN It is advisable to clean the oven periodically. While it is still warm clean with a cloth soaked with warm water and detergent, followed by a careful rinsing and drying. The bottom of the oven can be easily extracted and washed in the washbasin together with dripping-pan and gridiron shelf. iMPORTANT: Check the wear of the gas hosepipe connecting the cooker to the cylinder and replace it in case of anomalies. It is recommended to change it yearly; in any case within the date impressed on the hose. The replacement of spare parts and maintenance operations shall be carried out by qualified personnel only. if it is necessary to intervene on gas door placed under the cook-top (thermostat valves , injectors , etc. ) unscrew the two screws fixing the top on the back and after taking away the top support grids and burners, lift it by turning it on back pins. It is placed on the lower side of the chafing dish or on the back of the cooker. With all data and technical documentations of the cooker, the technician will be able to supply with the requested parts and start the repairing of his competence. - Sprinkle the plug with a thin coat of special grease, insert it in its seat and rotate it few times. If you desire to use the oven without the timer function you should turn the knob to the symbol (manuel). Automatic working mode (postponed cooking start time) First you should set your cooking time (both the "AUTO" and the symbols will lit up) and then the cooking end time, the symbol will switch off as previously stated. The symbol will lit up again when the oven starts baking. When cooking time has run out, the symbol will switch off while the "AUTO" symbols flashes and the acoustic warning signal starts. Manual working Manual working is possible only after having cleared the automatic program by pushing button 3. the "AUTO" symbol disappears and no other symbols lit up. Acoustic warning signal The acoustic warning signal starts at the end of a program and lasts about two minutes. To interrupt it you should push one of the function buttons. Program start and check Program starts after about 4 seconds from the setting. it is possible to check the set program at any time by pushing the corresponding button. Correction and cancellation of program It is possible to correct the set program at any time by first pushing the relative programming button and then buttons 4 or 5. [. . . ] Once the proper injector has been assembled, remount the burner of the oven. C - Grill burner It is possible to enter the injector taking away the burner fixed on the top of the oven by the front screw D (fig. It is recommended to put the replaced injector in the proper accessory kit and preserve them. WARNING Check that the gas pressure at the entry of the appliance is the correct one. [. . . ]