User manual DE DIETRICH DTE1172X

[. . . ] The countertop must be bonded with heat resistant (212 °F /100 °C) adhesive to prevent distortion. The cooktop can only be installed as shown in the illustrations, while maintaining the required safety distances shown. Do not install the cooktop between 2 tall cabinets as this is a fire hazard. [. . . ] A minimum distance of 2" (50 mm) from the cooktop to the rear wall and a side wall must be maintained for safety. To eliminate the risk of burns or fire by reaching over heated surfaces, cabinet storage space above the cooktop should be avoided. If cabinet storage is necessary, the risk can be reduced by installing a venting hood to project horizontally a minimum of 5" (127mm) beyond the bottom of the cabinets. 4 recommended 2" 50mm b not recommended. a Minimum distance between the cooktop and a wall or cabinet = 2" (50 mm) not allowed IMPORTANT SAFETY INSTRUCTIONS This equipment has not been designed for maritime use or for use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for an installation in these applications. Please contact the nearest Miele Dealer or Technical Service Department with specific requirements. Because of the heat radiated downwards from this type of appliance we do not recommend installing it over a drawer. It should be installed in a cabinet base unit with a dummy drawer front and an additional protective base between the appliance and the cabinetry. If, in spite of this, there is a drawer directly underneath the cooktop, do not store aerosols, combustible liquids or easily flammable materials in it. ^ Then with a hand on each side of the cooktop press down on the edges evenly until it clicks into position. When doing so make sure that the cooktop seal sits tightly on the countertop to ensure a correct seal is provided. The cooktop can now only be removed with a special tool. The cooktop must not be permanently sealed into the countertop when installed. If the cooktop is sealed into position, the countertop or appliance could be damaged if the cooktop needs to be removed for maintenance or service. The sealing strip under the edge of the top part of the cooktop provides a sufficient seal for the countertop. 8 Electrical connection , CAUTION: Before servicing, Power supply The cooktop is equipped with a flexible power cord consisting of 3 wires ready for connection to a grounded power supply: disconnect the power supply by either removing the fuse, shutting off the power main or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer will not be held responsible. Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. [. . . ] Repairs and service by unqualified persons could be dangerous and the manufacturer will not be held responsible. Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent machine damage. [. . . ]