User manual DE DIETRICH DVH1084J

[. . . ] It's your responsibility to use common sense, caution, and care when installing, maintaining, and operating the dishwasher. Samsung is not liable for damages resulting from improper use. IMPOrTANT SAfeTy INSTrUcTIONS What the icons and signs in this installation guide mean: WARNING Hazards or unsafe practices that may result in severe personal injury or death. Hazards or unsafe practices that may result in personal injury or property damage. To reduce the risk of fire, explosion, electric shock, or personal injury when using the dishwasher, follow these basic safety precautions: CAUTION CAUTION Follow directions explicitly. [. . . ] Select a location with sufficient space for the dishwasher door to open easily and with enough space between the dishwasher and the wall (at least 0. 1 in (2 mm)). If the dishwasher is installed in a corner, ensure that there is a clearance of more than 2 in. Cut a hole into the side of the wall where the sink is as shown in Figure 1 below. If there is an additional level in the sink cabinet and it is higher than the connections on the dishwasher, make two holes as shown in Figure 1-2. The wall at the back must be free of obstructions. <figure 1-1> <figure 1-> The hole for the water supply line, drain hose and power cables. _ installing the dishwasher STep WATer SUPPly reqUIreMeNTS 1. The dishwasher can be connected to either the hot or the cold water supply. If the temperature of the water supplied to the dishwasher is below 149 °F (65 °C), connect it to the hot water supply. If it is higher than 149 °F (65 °C), connect it to the cold water supply. Ensure that the water supply valve is turned off before connecting the water supply line to the dishwasher. Seal the water supply line connections using teflon tape or sealing compound to stop any water leakage. Make sure to keep the junction box cover you removed as it is used in STEP 10. When the countertop is made of wood or a material that is not damaged by drilling, locate the two (2) Installation brackets that were supplied with the dishwasher. (Refer to the figures in STEP 8. ) <figure > 02 INSTAllING The dIShWASher Kick plate <figure > A A B C B C Junction box Strain relief installing the dishwasher _11 installing the dishwasher STep PlAcING The dIShWASher ANd cONNecTING WATer SUPPly lINe 1. Adjust the four leveling legs at the bottom of the dishwasher after measuring the height of the cabinet opening from under the countertop to the floor. Locate the water supply line for connecting the inlet valve on the left and the power cable for connecting the junction box on the right. Place the dishwasher so that the water supply line and the power cable are located in the channels at the base of the dishwasher. Use standard duct tape to secure the water line and electrical cable to their adjacent channels in the base. Pull the drain hose through the hole in the side wall to the sink. Slide the dishwasher carefully into the installation space. Connect the water supply line into the elbow joint. CAUTION Do not place the dishwasher on the water supply line, drain hose or power cable. Also, make sure they are not folded or twisted. [. . . ] If there is no air gap, make sure to hang the middle of the drain hose in a high location to prevent backflow (see the figure below). CAUTION Be careful when cutting off the end of the drain hose as there is a risk of injury. Clean around the sink's drain connection so that it does not damage the hose. Check for any foreign items in the drain hose and remove them. <figure 11> 1 in. (25 mm) (19 mm) (13 mm) If required, cut off the end of the drain hose at one of the dotted lines. <figure 1> Dishwasher Sink Drain hose min. [. . . ]