User manual DECATHLON MAGNET 4000

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] You can adapt the amount of rinse aid used by the dishwasher: regulate the adjuster F which you will find under lid C. You can choose from six different positions. Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, turn the dosage adjuster to a higher setting. If, on the other hand, the dishes have white streaks, then turn the dosage adjuster down to a lower setting. 16 ARISTON DISHWASHER - Instructions for installation and use A wash cycle for every degree of soil Dishwasher washing guarantees your dishes will be cleaned in a hygienic setting for safer, cleaner results. Salt, rinse aid, the right amount of detergent and the correct wash cycle: this is the formula to get the best results and to keep your dishwasher in shape Select the right wash cycle D ISHWASHER Select the right wash cycle for your dishes. Selecting the most suitable wash cycle for the load ensures clean dishes and a more convenient use of water and electricity. &\FOH &\FOH VHOHFWLRQ LQVWUXFWLRQV &\FOH GHVFULSWLRQ 'HWHUJHQW IRU SUHZDVK  ZDVK 5LQVH $LG :DVK F\FOH GXUDWLRQ WROHUDQFH “  , QWHQVLYH :DVK Very dirty dishes and pans (not to be used for delicate items) Pre-wash at 40°C Extended wash at 65°C 2 Cold rinses Hot rinse at 65°C Drying   J  Cycle for normally dirty pans and dishes. 'DLO\ :DVK Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes.  5DSLG Economic and fast cycle to Short wash at 50°C be used for slightly dirty Hot rinse at 62°C dishes. This electric household appliance should be connected to the water mains using the cold water supply hose provided with the appliance only. In the event of replacements, use original spare parts only. Connect the cold water supply hose to a 3/4 gas threaded connection, taking care to screw it tightly onto the tap. If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it is clear and free of impurities before making the connection. If this precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Anti-flooding protection Your dishwasher is provided with a special system which blocks the water supply in the event of leaks inside the appliance. It is further equipped with a water inlet hose that can withstand extremely high pressures and that turns bright red in the event of breakage. Safety in the event of flooding is ensured by the second clear hose that contains the former and thus highlights the latter when it has turned bright red. [. . . ] Check the sprayer arms regularly and clean them once in a while (letters F and I “How is it made?Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. [. . . ]