User manual DEI AUTOMATE AM7 Owners Guide

[. . . ] Model AM7 O Owner's Guide limited lifetime consumer warranty Directed Electronics ("Directed") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. This warranty is non-transferable and is automatically void if: the original purchaser has not completed the warranty card and mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date code or serial number is defaced, missing or altered; the unit has been modified or used in a manner contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or construction. The warranty does not cover damage to the unit caused by installation or removal of the unit. [. . . ] The shutdown toggle switch is put into the OFF position. The pre-programmed run time (12, 24, or 60 minutes) has elapsed. Transmitter buttons is pressed twice within 3 seconds. 19 © 2005 directed electronics--all rights reser ved rear defogger To turn the rear defogger output OFF: 1. Simultaneously press & release the on the remote control. The rear defogger output will no longer activate when the vehicle is remote started. note: If the remote start is on the parking lights will turn off then flash 2-times before returning to their normal output and the defogger output, if active, will cease. + + buttons To turn the rear defogger output ON: 1. Simultaneously press & release the on the remote control. The rear defogger output will once again activate when the vehicle is remote started. note: If the remote start is on the lights will turn off then flash 3-times before returning to their normal output and the defogger output will activate as programmed. + + buttons note: If the temperature is greater than 55° F at the time of remote start activation, the rear defogger will not activate for that start. 20 © 2005 directed electronics--all rights reser ved valet take-over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on. To perform Valet Take-Over: 1. Before turning off the engine, press and release optional momentary switch). Then wait five seconds. twice within 3 seconds on the transmitter (or press and release the 2. Turn the ignition key to the OFF position. The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous Remote Start section for a complete list of shut-down inputs. ) note: This feature will not work if the brake pedal is being pressed. short-run/turbo Short run turbo mode keeps the engine running after arriving at you destination for a programmable period of 1, 3, 5 or 10 minutes. This allows the system's timer to conveniently cool down the turbo after you have left the vehicle. © 2005 directed electronics--all rights reser ved 21 To activate: 1. Remove your foot from the brake pedal and leave the engine running. Press and release the and buttons at the same time. The lights will flash to indicate the remote start has entered short run turbo mode. Turn off the key, the engine will keep running. The engine will turn off after the programmed run time. timer/temperature mode By pressing the remote and buttons the parking lights will flash 4 times and then start the vehicle and run for the set duration in timer mode. The remote start can be shut off by the transmitter by pressing the remote start button and remain in timer mode, but if any other shut down zones or the ignition becomes active the timer mode will cancel. The vehicle will confirm with 4 parking light flashes. A 1-second delay will start. © 2005 directed electronics--all rights reser ved 4. The system will start the car and will run for the specified . If the duration, unless shut down by the remote start button shut down with the remote start button system will remain in timer mode. [. . . ] The vehicle is never prevented from cranking when the system is disarmed, in Valet Mode, or if the starter interrupt switch itself fails. Your system has featureready circuitry for the starter interrupt, however installation may require additional labor. Input: A physical connection to the system. An input can be provided by a sensor, pinswitch or by existing systems in the vehicle, such as ignition or courtesy lights. LED: A red light mounted at a discretionary location inside the vehicle. It is used to indicate the status of your system. Shock Sensor: This system has a dual zone shock sensor. [. . . ]