User manual DEI HVM580 Owners Guide

[. . . ] This warranty is non-transferable and does not apply to any Product that has been modified or used in a manner contrary to its intended purpose, and does not cover damage to the Product caused by installation or removal of the Product. This warranty is VOID if the product has not been purchase from an authorized Directed dealer or has been damaged by accident or unreasonable use, negligence, acts of God, neglect, improper service or other causes not arising out of defect in materials or construction. This warranty does not cover the elimination of externally generated static or noise, or the correction of antenna problems or weak television reception, damage to tapes, video games, software, camcorders, discs, speakers, accessories or vehicle electrical systems, cosmetic damage or damage due to negligence, misuse, abuse, failure to follow operating instructions, accidental spills or customer applied cleaners, damage due to environmental causes such as floods, airborne fallout, chemicals, salt, hail, windstorms, lightning or extreme temperatures, damage due to accidents, road hazards, fire, theft, loss or vandalism, damage due to improper connection to equipment of another manufacturer, modification of existing equipment, use of a faulty tape cartridge or cleaning of the VCR head, or Product which has been opened or tampered with for any reason or which has been damaged due to alteration or service performed by anyone other than Directed Electronics, Inc. ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, AND WARRANTY OF NON-INFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. [. . . ] Retain this manual for future reference. Do not remove any WARNING stickers on the unit. Do not use any chemical solvent, cleaning agent or corrosive detergent to clean away dirt on the surface of the screen. Doing so may cause irreversible damage to the surface of the LCD screen. To clean off dirt or fingerprints, it is recommended that a soft-damp lens-cleaning cloth be used. Using spare parts from another manufacturer may cause permanent damage to the unit. Avoid installing the monitor screen in a position that is exposed to direct sunlight and hot air vents. Install the unit in a dry location, avoid condensation. Ensure that all wiring is properly connected before operating the unit. Should the LCD panel break, avoid contact with the broken glass or fluid leaking out from the enclosure. If you come into contact, flush and clean the affected areas with plenty of water. When operating the monitor, avoid touching or pressing on the LCD screen. Excessive force will damage the LCD screen. When installing this unit in a vehicle, ensure that the installation and use of this unit is in compliance with local vehicle rules and regulations. Before replacing a blown fuse, turn the unit off and disconnect all power. Ensure the replacement fuse is of the same rating (5A) of the fuse being replaced. If during operation the unit overheats or malfunctions, turn off the power and contact your dealer. Do NOT disassemble the unit, there are no user serviceable parts in the unit. The battery (CR2025) in the remote control has a useful lifetime of approximately 6-months. To ensure proper and reliable operation, replace the battery in a timely manner. [. . . ] To install the monitor into the seat head rest you must ensure that the monitor connecting cable assembly has already been pulled through the mounting shroud and the head rest support tube. (As an alternative the cable can be routed beside the headrest support tube. ) 4. Ensure that the the cable assembly is routed to prevent damage when the seat is adjusted. If the connecting cable is routed along side the headrest support tube ensure that it routed so that it will not be damaged when the headrest is adjusted. MOUNTING SHROUD HEADREST 1 DIN CONNECTOR 2 DIN CONNECTOR LCD CABLE ELECTRICAL CABLE 3 HEADREST SUPPORT TUBE 5. [. . . ]