User manual DEI ORION C5.2

[. . . ] Your Product Information Serial Number: Model Number: Date of Purchase: WHAT'S IN THE BOX Included in this box are all the necessary mounting hardware and cables for your basic installation. Listed below is a detailed list of the components included in this system package. Quantity Description 1 Installation and Operation Manual 2 C-Series Tweeter Elements 2 Surface mount hardware 2 C-Series midrange 2 Passive crossovers 2 Cables (speakers to crossover) 2 Cables (crossover to amplifier) 1 INSTALLATION The performance of the C-Series component loudspeaker is directly proportional to the quality of installation. Care taken during the installation process will be rewarded with years of satisfying performance. [. . . ] A hole can be cut either with a pair of metal tin snips, an air or jig saw, or with a hole saw corresponding to the size of the midrange listed below. · 4-7/8" Hole Saw (5" woofer installation) · 5-5/8" Hole Saw (6" woofer installation) WARNING: Window mechanisms and electrical wires have a nasty habit of hiding where you least expect. Step 5: Run the speaker wire to the speakers. Make sure to keep wires away from sharp metal or other edges. When passing through metal , use a protective grommet. Step 6: Using the plastic grille ring as a template, mark the mounting holes with a pen. Step 7: Pre-drill mounting holes using a 1/8" drill bit. WARNING: Window mechanisms and electrical wires have a nasty habit of hiding where you least expect. Step 8: Pull the wire through the speaker opening and connect to the speaker. Be sure to observe proper midrange polarity during this process. 3 Step 9: Mount the speaker- The speaker is placed in the grille ring from the front. Place the speaker and the grille ring in the installation hole. Align the mounting screw holes and drive in the four mounting screws. Push the perforated metal grille back into the grille ring. INSTALLING THE TWEETER SURFACE AND ANGLE MOUNTING Step 1: Determine where the tweeter will be mounted. Make sure there is a flat area large enough for the tweeter to fit properly for surface or angle mounting. Step 2: Check to make sure the space you have chosen for the speaker will not interfere with the operation of the vehicle. Step 3: Pre-drill mounting holes using a 1/8" drill bit. WARNING: Window mechanisms and electrical wires have a nasty habit of hiding where you least expect. Step 4: Drill a 3/8" hole for the tweeter wire. If drilling through a metal surface, use a grommet to protect the wires. Step 5: Run the tweeter wire through the wire hole and attach the wires. Be sure to observe proper polarity during this process. Step 6: Mount the tweeter housing using the supplied hardware. [. . . ] Units which are found to be damaged by abuse resulting in thermally damaged voice coils are not covered by this warranty but may be replaced at the absolute/sole discretion of Directed. ALL WARRANTIES INCLUDING BUT NOT LIMITED TO EXPRESS WARRANTY, IMPLIED WARRANTY, WARRANTY OF MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, AND WARRANTY OF NONINFRINGEMENT OF INTELLECTUAL PROPERTY ARE EXPRESSLY EXCLUDED TO THE MAXIMUM EXTENT ALLOWED BY LAW, AND DIRECTED NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. DIRECTED HAS ABSOLUTELY NO LIABILITY FOR ANY AND ALL ACTS OF THIRD PARTIES INCLUDING ITS AUTHORIZED DEALERS OR INSTALLERS. Unit must be returned to Directed, postage pre-paid, with bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number, and address, authorized dealer's name and address, and product description. [. . . ]