User manual DEI ORION WCC D5000

[. . . ] Warranty LIMITED TWO YEAR CONSUMER WARRANTY: Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two-year period, there will be no charge for this replacement PROVIDED the unit is returned to Directed, shipping pre-paid. If the unit is installed by anyone other than an authorized Directed dealer, the warranty period will be one year from the date of purchase by the dealer as indicated by the date code marking of the product. [. . . ] This connection provides +12V main power to the amplifier. Power wires must be fused no more than 18" from battery. Terminate both grounds of the amplifier to a good chassis ground as close as possible to the amplifier. Connect REM terminal to remote turn-on lead from source unit. This connection provides +12V power to turn-on the amplifier. Add an extra ground wire between the negative terminal of the battery and the chassis. Either dual 4 AWG or single 1/0 AWG is recommended. The addition of a ground wire from the battery to the chassis of the vehicle improves the ability of the battery to supply power to the amplifier. This is recommended because the current delivery of the factory electrical system was designed only to accommodate electronics supplied by the auto manufacturer. The WCC-D5000 has two separate four-gauge power and ground inputs. Both pairs of connections must use 4 AWG power wire for proper operation. Failure to do this may damage the amplifier and is not covered under warranty. The WCC-D5000 cannot be operated in a bridge or strapped configuration, attempting to do so will damage the amplifier. ©2004 Directed Electronics, Inc. NOTE: WARNING! 12 Speaker Connections The WCC-D2400, and WCC-D5000 amplifiers offer two positive and two negative output terminals for ease of connecting the speakers to the amplifier. Since these are mono amplifiers, the speaker connectors are paralleled internally. Each amplifier is stable to 1W. Bridging For bridging into a single speaker load, the WCC-D2400 has the ability to be bridged with another amplifier of the same model. To do this you must utilize the COPY/GAIN/MASTER switch settings. For the MASTER amplifier, set the switch setting to MASTER. This will route the signal through RCA to the other (slave) amplifier. Refer to Auxiliary Output Configuration section of this guide. To set the PHASE switch on the (slave) amp, move the phase switch from 0 to 180, exactly opposite of the master amp. Refer to the Phase Switches section of this guide. On the (slave) amplifier be sure to turn off all crossovers. [. . . ] Enjoy your awesome West Coast Customs by Orion sound system. Step 5 Step 6 Step 7 Step 8 Step 9 Step 10 Step 11 Step 12 ©2004 Directed Electronics, Inc. 17 Troubleshooting Tips Symptom No output Low or no remote turn-on Check remote turn-on voltage at voltage amplifier and repair as needed. Check power wire's integrity and check for speaker shorts. Probable Cause Action To Take Fuse blown Power wires not connected Check power wire and ground connections and repair or replace as needed. Audio input not connected Check RCA connections and repair or replace as needed. [. . . ]