User manual DELONGHI 082067E

[. . . ] - Check also that the current capacity of your fuses. CONNECT YOUR HEATER TO EARTH PROVIDED SOCKET ONLY. - This appliance complies with EEC Directive 89/336, relating to electro-magnetic compatibility. [. . . ] Set the temperature to 5°C with the " -" button. When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, thereby preventing freezing, at minimum energy consumption. N. B. This function is not guaranteed in the event of power failures, lasting more than 2 minutes. 5) PROGRAMMING THE ELECTRONIC TIMER The timer allows you to set 2 programmes in a 24 hour period. 1- Press the " AUTO" button, this accesses the 1st programme (programme A). The yellow timer ON lamp will light up. 9 GB 20-07-2001 15:27 Pagina 10 2- Set the start time for your programme by pressing the "HOUR" button to set the hour and the "MIN" button to set the minutes. 3- To select how long you require the heater to be on, push the "+min" button repeatedly until your chosen operating timespan appears. The time periods you are able to choose from are (15', 30', 45', 1hr, 2hr, 4hr (max)). 4- To program a second time period (programme B), press the " AUTO" button twice and then proceed as above to select the start hours and minutes. The set time will be the same as for the first programme. When the operating time is changed, the time of both programmes is updated. 5- Use the " +" or " -" buttons to set the desired comfort temperature, as described above. AUTO AUTO AUTO °C : O O : 0 Display when setting programme A Display when setting programme B Display when setting for 45 mins operating time 6-When set in this way the heater will automatically switch on at the set time for the designated time period and automatically maintain the preset comfort temperature. To cancel a programme, press the " AUTO" button and then the "hour" buttons until the display shows as below. : TIMER OVERRIDE To operate the appliance without using the timer, press the "ON MODE" button (Fig. 3). IMPORTANT You must leave the heater plugged in at the mains socket to keep the heater's memory programmed. If the heater loses its electricity supply for more than 2 minutes, e. g. if unplugged or in the event of a power failure, the heater's programmes will be lost, and the timer will not work until reset. In such an instance the display will show flashing numbers. On using the appliance for the first time, turn it on to the maximum power and the highest temperature setting for at least 2 hours. [. . . ] During this operation, the room in which the radiator is located must be ventilated. - It is perfectly normal for the radiator to make "creacking" sounds when used for the first time. - The heater must not be located immediately below a fixed socket-outlet. [. . . ]