User manual DELONGHI BAR 6F S

[. . . ] Please read this instruction booklet carefully before installing the appliance and keep it handy for future consultation. In so doing you will obtain the best result and maximum safety in its use. sAFETY INSTRUCTIONS Do not immerse the appliance in water. Do not operate the appliance without first having water in the tank. [. . . ] 5) and line up with the arrow marked on the machine lid (fig. At this point press the filter-holder upwards while at the same time rotating it to the right all the way. It does not matter if the filter-holder's handle is not centrally aligned with the machine. it is important that the bowl be firmy set in its housing. 8 The carafe with lid must be positioned under the filter-holder so that the 2 holes under the filter-holder are inside the opening on the carafe's lid (fig. Make sure that the steam knob is turned off. 9 Set the coffee selector (L) to the type of coffee required: "LIGHT" for a weak coffee, "MEDIUM" for a normal coffee, "STRONG" for a strong coffee (fig. 11 About three minutes are required before the coffee begins to be dispensed. wait until all the water of the boiler has been dispensed. Turn off the power switch after the coffee has been dispensed. 12 Before unscrewing the boiler cap or removing the filter-holder, residual pressure must be released by slowly turning the steam knob (fig. 10) so that the residual steam can escape. In models with the "safety cap", it is not possible to open the boiler cap when the boiler is hot as the cap turns without unscrewing. If it has to be removed for any reason, it is always necessary to let off steam from the boiler using the steam knob as 13 To remove coffee grounds from the filter-holder, turn upside down and knock it repeatedly until all grounds have been removed (fig. 11), or rinse the filter holder unit under running water and let drip dry. NOTE To eliminate the "new" smell, the first time you use the coffee machine, carry out a number of coffee cycles without using coffee. CUP ADAPTOR ASSEMBLY The adaptor (M) must be used every time the coffee is required to be made directly in the cup. For it to be assembled, it only needs to be inserted in the lower part of the filter-holder (fig. PREPARING CAPPUCCINOS 1 Prepare the coffee as described in points 1 to 10 of the paragraph "PREPARING THE COFFEE", using the amount of water necessary to obtain 2 cappuccinos as shown in the table at the end of the text. Note that more water is needed to make 2 cappuccinos than to make 2 normal coffees as steam is required in order to emulsify the milk. [. . . ] Turn on the steam knob for a few seconds while the vinegar flows through the filter-holder. This will clear any milk residue from the inside of the tube. Close the steam knob (the vinegar will continue to flow into the carafe). When no more vinegar flows into the carafe, turn the switch to OFF and allow the machine to cool. [. . . ]