User manual DELONGHI BARM 110

[. . . ] bar 110 GB 20-11-2000 11:47 Pagina 6 ENGLISH Read this instruction booklet carefully before installing and using the machine. In this way, you will obtain the best possible results and maximum operating safety. SAFETY WARNINGS Read the following instructions carefully!· Before use, check that the power supply corresponds to the voltage shown on the serial number plate. Connect the appliance only to properly-earthed power outlet (minimum 10A). [. . . ] Then refill the milk tank with water and repeat the whole operation. · Repeat this at least five or six times to completely pre-wash the system. · The machine is now ready for normal use. Features To fit the filter-holder, place it under the boiler nozzle (fig. Then push the filter-holder upwards and at the same time rotate it towards the right as far as it will go. A handy compartment in the lower section of the casing can be used to store the measuring spoon (fig. 11) Remember that the left side of the appliance becomes 7 USING THE COFFEE-MAKER FOR THE FIRST TIME Remove the packaging and take out the bag containing the accessories. When the appliance is new, the following accessories must be washed with lukewarm water and detergent then rinsed thoroughly: filter, cup, measuring, filters, water tank, pressing spoon. The internal circuit of the coffeemaker must then be pre-washed as follows: Filling the tank Remove the reservoir by pullling it sideways, at the same time lifting the tubes (fig. Rinse the reservoir and fill with fresh water up to the upper mark (fig. Inspection of the water level is facilitated by a ball-shaped float. Replace the reservoir in its housing, ensuring that the tubes are immersed in the water (fig. A simpler way of filling the reservoir is to pull it out just enough to be able to pour in water directly from a jug. Remember to clean the reservoir regularly. bar 110 GB 20-11-2000 11:47 Pagina 8 very hot due to the positioning of the boiler. MAKING ESPRESSO COFFEE Some suggestions · Always use cold water and keep the tank clean. · Begin brewing the coffee only when the warning light "OK" coffee ready is lighted. · Before making coffee, warm the coffee cups in advance with hot water. · For best results, it is important the coffee grounds being used are those ground especially for home espresso machines. · The ideal dose of coffee is one level measure (7 grams) for one cup of coffee and two measures (7 + 7 grams) for two cups. Preheating the Coffee Machine In order to have coffee that is the right temperature, it is important to pre heat the machine by turning it on at least half an hour before beginning the coffee making operations and to make sure to leave the coffee filter holder attached. After the half hour, as soon as the "OK" warning light (24) turns on, make the coffee according to the directions given below. Alternatively, in order to pre-heat the machine more quickly, you may also proceed in this way: · Turn the machine on using the "ON/OFF" switch (fig. · Attach the coffee filter holder with the filter but without coffee. [. . . ] · This operation rinses the tank and all the internal parts. We recommend a more thorough clean once a week, as follows: · Switch off the machine, unplug the cord and leave the machine to cool. · Remove the milk tank lid (8) (fig. 15). · With one hand, push the release lever to the left and raise the tank at the same time (see fig. 16). [. . . ]