User manual DELONGHI BBH 100W/ S

[. . . ] FITTING OF FEET Remove the feet and the fastening screws from the bag. Turn the appliance upside-down on a soft surface, to avoid ruining the paintwork. Insert the feet as shown in the figure 1, making sure they are inserted completely: the teeth A at the bottom must be coupled to the feet. Finally, fasten the feet using the two screws. A A FIG. [. . . ] The blue wire must be connected to the terminal marked with the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red. 2 4. 2) · Insert the plug into the mains electrical socket and switch on. · Turn the thermostat knob in a clockwise direction until it reaches the maximum setting. · Heating at full power: press both the foot switches (min + med). · Heating at medium power: press only the foot switch "med". Only the light "med" will come on. · Heating at minium power: press only the foot switch "min". Only the light "min" will come on. foot switches FIG. SETTING THE THERMOSTAT When the room has reached the required temperature, turn slowly the thermostat knob anticlockwise until the lights go out but no further. Having been set in this way, the temperature will automatically be regulated and kept at a constant level by the thermostat. FROST STAT FUNCTION Set the switch to "on" and then turn the thermostat knob to " " setting. When it is set in this way the appliance keeps the room at a temperature of approx. 5°C, thereby preventing freezing, with minimal energy expenditure. MAINTENANCE Before carrying out any maintenance, unplug the heater from the mains and wait for it to cool. The convector requires no particular maintenance. It is sufficient to remove the dust with a soft, dry cloth. If necessary remove concentrated areas of dirt with a vacuum cleaner. WARNINGS ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. - Do not use the heater in a bathroom or in the vicinity of bathtubs, washbasins, showers or swimming pools. [. . . ] - It is normal for the heater to make "crackling" noises when reheating and cooling. IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. 3 - - A safety device intervenes and turns off the appliance in the event of overheating or because the appliance is positioned in a strong draught of air. To reactivate it, remove the plug from the electrical outlet, allow the appliance to cool (about 5'), remove the cause of the overheating/draught and then reconnect the appliance to the mains and turn it back on. [. . . ]