User manual DELONGHI BBH 100WS

[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] INSTALLATION Install the appliance on the floor near the coldest window in the room, or in the desired position. The appliance must not be installed immediately below a permanent mains outlet. Position the appliance so that the plug and the outlet can be easily reached even after installation. ELECTRICAL - Before plugging the appliance into an electrical outlet, carefully check that your home's mains voltage corresponds to the voltage (V) indicated on the appliance, and that the outlet and mains supply line are sufficient to power the appliance. ADJUSTING THE THERMOSTAT When the room reaches the desired temperature, slowly move the thermostat until the light goes off, and no further. When set in this way, the appliance will switch on whenever the room temperature falls below 5°C, avoiding excessive cooling down with minimum energy consumption. MAINTENANCE Always unplug the appliance from the electrical outlet before beginning any cleaning operations. The electric convector does not require special maintenance. Simply dust it off with a soft, dry cloth; only clean when cold. never use abrasive powders or solvents. If necessary, use a vacuum cleaner to remove the dust. WARNINGS ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. ⷠDo not make use of this heating convector in the immediate proximity of bathtubs, showers, washbasins, pools, etc. In addition, this appliance must never be placed directly under a permanent electrical outlet. ⷠDo not rest the power cable on the appliance when it is hot. ⷠUse this heating convector only and always in an upright position. [. . . ] ⷠA special device switches the appliance off in the event of overheating or the presence of strong draughts. To restart the appliance, unplug it, allow it to cool down (around 5 minutes) and remove the cause of the overheating; then plug the appliance back in and switch it on. ⷠAs for any electrical appliance, caution and common sense must be applied when using the appliance, especially when children are present. [. . . ]