User manual DELONGHI BG22

[. . . ] Contact the nearest authorized service facility for examination, electrical or mechanical adjustment, or repair. This heater is not intended for use in bathrooms, laundry areas, or similar indoor locations. Never position the appliance where it may fall into a bathtub or come in contact with water. Do not run the power cord under carpeting. [. . . ] Plugging the heater into a worn outlet may result in overheating of the power cord or maycause the risk of fire. If the supply cord is damaged, to reduce the risk of malfunction it must be replaced by the manufacturer, its service agent, or a licensed and qualified professional. Do not use this appliance with an extension cord or outlet strip. Connect the appliance directly to a suitable outlet. Make sure that the plug is fully inserted into the outlet. Wall outlets may deteriorate with time, so check the plug periodically for signs of overheating or deformation. If the outlet has deteriorated, stop using it and have it repaired. Check that neither the appliance nor the power cord have been damaged during shipping. Make sure that no styrofoam or other packing materials remain in the appliance. It may be necessary to pass over the appliance with a vacuum cleaner. The first time the appliance is used, run it at the maximum power for at least two hours. Note: The room may require up to an hour to reach the desired temperature depending on room size and conditions. USE OF THERMOSTAT The thermostat operates according to room air temperature, rather than radiator temperature. Turning it counter-clockwise to smaller numbers would decrease the temperature; clockwise to greater numbers would increase the temperature. Antifreeze function Turn the thermostat dial to the position and push the switches on. The appliance will maintain a minimum room temperature of approximately 41°F (5°C), thus preventing freezing while conserving energy. REMINDER To completely shut the heater off, MIN/MED switches must be set in the "0" position. Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). There is only one way it can be plugged into a power supply. If you are unable to insert the plug fully into the outlet, try again by turning it the other way. If it would still not go in, it is probably due to an obsolete outlet which should be replaced. Do not tamper with the plug or outlet to defeat the purpose of this safety mechanism. 4 A safety device A safety device switches the heater off in the event of overheating. [. . . ] The repaired or new model will be returned at the company expense. This warranty shall apply only if the appliance is used in accordance with the factory directions, which accompany it, and on an Alternating current ( AC ) circuit. This warranty runs for one year (1) from the purchase date found on your receipt and applies only to the original purchaser for use. The warranty does not cover defects or damage of the appliance, which result from repairs or alterations to the appliance outside our factory or authorized service centers, nor shall it apply to any appliance, which has been subject to abuse, misuse, negligence or accidents. [. . . ]