User manual DELONGHI BHF 3

[. . . ] 4) when installed in a bathroom or shower room and under all circumstances away from taps, basins and showers, etc. - Remove the screw in the bottom of the base and unclip the base, pulling it out from the rear. - Clip the fan heater onto the bracket, slanting it slightly (Fig. 3) and then fix it in place using a screwdriver, turning the screw in the top part of the mounting bracket clockwise. ELECTRIC CONNECTION Before fitting the plug in the mains socket, make absolutely sure that the voltage of your mains electricity supply is the same as the value in V shown on the heater. [. . . ] Turn the thermostat knob to the "summer use" position On models fitted with electronic timer, slide the starter indicator (fig. 5) to position "I"; the indicator lamp will come on. The fans only will be switched on when the fan heater has been set in this way. Switching off the heater Turn the function selector knob back to its "O" position (Fig. On models with the electronic timer, you must also press the start pushbutton (Fig. 5) until moving the display line to the "O" position (Fig. 6). ELECTRONIC TIMER (not on all models) Setting the time and day of the week Set the timer to the correct time, proceeding as follows: pushbutton and pushbutton (Fig. 5) simultaneously until the display - Press the shows the hours for the correct time, then release both pushbuttons. PROGRAM START PROGRAM END PROGRAM NUMBER PILOT LIGHT fig. 6 5 - Press the pushbutton and pushbutton (Fig. 5) simultaneously until the display shows the minutes for the correct time, then release both pushbuttons. (Keep both pushbuttons pressed for more than 3 seconds to move through the hours and minutes in fast mode). How to program the timer (up to a maximum of 6 programs) 1. Move the sliding indicator to "AUTO" (fig. 5). Press the pushbutton to access the 1st operation program. The message ON will be shown on the display together with the program number (1). Set the start of program time by pressing the pushbutton to set the minutes. Press the pushbutton again to set the end of program time. The message OFF and 1 will be shown on the display (Fig. Now set the time using the and pushbuttons. Press the pushbutton to access the successive programs (up to 6). The message ON and 2 will be shown on the display. [. . . ] To reset the unit for normal operation, remove the plug from the mains socket for a few minutes, eliminate the cause of the overheating (e. g. air intake or outlet grilles obstructed) and then plug the fan heater back in again. Contact your nearest Technical Assistance Service if the fan heater does not start operating normally again. Never direct the fan heater's air flow towards furniture, curtains, spray cans and inflammable material. [. . . ]