User manual DELONGHI CH15

[. . . ] Arrange cord away from traffic area and where it will not be tripped over. To disconnect heater, turn controls to off, then remove plug from outlet. Connect to properly polarized outlets only. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the heater. [. . . ] Dust and lint on the heating element can obstruct the free flow of air. Operating with air openings obstructed could cause a dangerous condition. Make sure that no pieces of polystyrene or other packaging material have been left into the appliance. It may be necessary to pass over the appliance with a wacuum cleaner. When switching on the appliance for the first time, allow it to run at full power for about 1 hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is located is well ventilated during this operation. It is not advisable for the appliance to be positioned where it is exposed to draughts which might prevent it from working properly. SAVE THESE INSTRUCTIONS 3 HOW TO USE YOUR HEATER FEET ASSEMBLING Remove the feet from the packing. Fit the feet to the appliance as follows: 1 Insert the anchor pins (A) into the slots and turn the foot until it clicks into position (fig. 2 Fasten the feet in position using the screw (fig. 2 BE CAREFUL Operate the heater in upright position only. Any other position could create hazard situation!The appliance is fitted with a tilt-swich which turns the appliance off if it should fall over. To restart the appliance, simply place it upright again. LOCATION Place heater on floor beneath coldest window in the room or any desired location. Your heater will minimize the effect of cold drafts. The heater must not be located immediately below a socket-outlet. SWITCHING HEATER ON The heater must be connected to a properly polarized A/C 110/120 V household outlet in perfect working conditions. Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater plug is fitted in. Turn the thermostat knob clockwise to the highest setting and push one or both switches on. Pilot lights will go on, indicating that unit is operating. REMINDER To completely shut unit off, both switches must be placed in "0" position (lights off). THERMOSTAT OPERATING 0 The thermostat operates on room air temperature and not heater temperature. [. . . ] Also, consequential and incidental damages resulting from the use of this product or arising out of any breach of contract or breach of this warranty are not recoverable under this warranty. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. If repairs become necessary or spare parts are needed, please write to: De' Longhi America Inc. 1-800-322-3848 The above warranty is in lieu of all other express warranties and representations. [. . . ]