User manual DELONGHI CKT 350

[. . . ] Never allow the appliance to be used by children or used without adult supervision. Do not touch the appliance with wet or damp hands. The metal sides of the toaster and the areas surrounding the bread slots (H) become very hot during use: operating the appliance should be carried out using only the plastic dials + handles. Bread is a foodstuff which may catch fire. [. . . ] If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. If the plug is a moulded-on type the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. Only 13amp replacement fuses which are ASTA approved to B. S. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. WARNING - THIS APPLIANCE MUST BE EARTHED Green and Yellow to Earth Blue to Neutral yy , , , , yy yy , , 13 amp Fuse Brown to Live Cord Clamp 5 ckt 350 GB 17-11-2000 16:02 Pagina 6 Your toaster features two sections, with independent operation. The large toasting slot is ideal for toasting large slices of bread, muffins, etc. DESCRIPTION OF THE APPLIANCE A Control lever (start/eject) B Large toasting slot C Small toasting slots D Slide-out crumb tray E "Toast one side only" button + light (large toasting slot section only) F "Stop /cancel" button G Browning control dial H Heating button + light (small toasting slot section only) I Defrost button + light (small toasting slot section only) Using the Reheat Button: (small toasting slot section only) Press down control lever (A) and press the reheat button (H). The reheat light will remain on whilst the reheat function is in use. Please note that this is a fixed reheat time which cannot be adjusted by the browning control. Using the toast one side only function button (large toasting slot section only) 1. Place the slice of bread in the large toasting slot (B). Turn the browning control dial to the desired position. (Normally it is better to select one position lower than for toasting on both sides. Press the control lever (A) down until it clicks into place. Press the toast one side only function button. The toast one side only light will stay on while this function is active. When the toasting time has elapsed, the toast will pop up automatically. N. B. : To prepare muffins, slice them in half and place them in the large toasting slot, with the cut sides facing outwards. Using the Stop/Cancel Button (for both sections) Should you want to interrupt the toasting process, simply press the stop/cancel button (F) at any time. Warning: Do not force control lever (A) to eject toast etc. [. . . ] Once cooled, turn toaster upside down and gently shake to remove the lodged item. Do not insert sharp objects such as knives, as this may damage the heating element. HINTS AND TIPS FOR BETTER TOASTING RESULT: The first time you use the toaster, you should do so without bread. This will pre-heat the new element and burn off any dust collected during the storage process If your toaster is not plugged in and switched on, the control lever (A) will not lock in the down position. [. . . ]