User manual DELONGHI COFFEE MAKER EC200B

[. . . ] EC190/200 intro 5-12-2001 13:43 Pagina 1 COFFEE MAKER Owner's instructions EC190/200 intro 5-12-2001 13:43 Pagina 2 ELECTRICAL CONNECTION (UK ONLY) A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. [. . . ] 2. Attach the empty filter holder (without coffee) to the machine by positioning it under the boiler outlet with the handle towards the left (fig 5). Push upwards and at the same time turn the handle as far right as possible. It does not matter if the handle is not centrally aligned with the machine, as long as the filter holder is firmly attached to the appliance. 2. Position a cup under the filter holder. Use the same cup that the coffee will be served in, so that it may be preheated. 3. Wait until the orange "OK" light comes on (fig 7) and turn the selector knob to the espresso function position (fig 8) Allow water to flow until the orange "OK" light goes out, then stop the flow of water by turning the selector knob to the boiler on function (fig 5) EC190/200 GB 5-12-2001 13:44 Pagina 8 6. To detach the filter holder, turn the handle from right to left. ATTENTION: to avoid spraying, never detach the filter holder while the machine is brewing coffee. 7. To remove the used coffee, hold the filter locked with the special lever that is built into the handle and let the coffee fall out by knocking the overturned filter holder (Fig. 8. To switch off the coffee machine, turn the selector knob on the appliance to the OFF position "O" (fig. HOW TO PREPARE COFFEE USING THE FILTER HOLDER FOR PODS (if fitted): · Preheat the machine as described in the `Preheating the Coffee Machine' section, making sure to leave the filter holder attached to the unit. Following this procedure ensures that the coffee is delivered at a hotter temperature, as well as guaranteeing that the seal of the filter holder gaskets is more effective. · Press the filter holder button and insert the pod into the filter (fig 15). Note: Use pods which conform to the ESE standard: this will be indicated on the packaging by the following symbol: HOW TO MAKE CAPPUCCINO 1. Prepare espresso coffee, using cups that are large enough for cappuccinos (see "How to prepare espresso coffee). 2. Turn the selector knob to the position (fig. 16) Wait until the orange "OK" light comes on, to indicate that the boiler has reached the ideal temperature for producing steam. 3. In the meantime, fill a container with approximately 3 fl. oz of milk for each cappuccino to be prepared. The milk must be cold from the refrigerator (not warm!). In choosing the container, bear in mind that the volume of the milk will increase by 2 or 3 times. NOTE: We suggest you use semi-skimed milk at refrigerator temperature. 4. Position the container with the milk in it under the milk frother (fig. If you use the "iIIycaffe" coffee pods, use the special filter holder. [. . . ] · The holes in the filter holder spouts are blocked. SOLUTION · Prepare the coffee again, pressing it more lightly and/or changing the powder · Clean the holes in the spouts. · Clean as indicated in the "Cleaning the espresso boiler outlet" section. · Press the tank lightly so as to open the valve at the bottom. Espresso coffee drips from the edges of the filter holder, instead of from its holes. ·Attach the filter holder on correctly and turn it all the way. · Have the espresso boiler gasket replaced at an Service Centre · Clean the holes in the spouts. [. . . ]