User manual DELONGHI CORDLESS METAL TRADITIONAL KETTLE KBX3030

[. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. [. . . ] Do not place any utensils into the kettle. The use of accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or personal injury. Never use the kettle without it's lid. Position the kettle properly on the power base before switching on. Use the kettle only with the power base supplied (and vice versa). Do not operate this kettle if the mains lead or plug is damaged, if the kettle malfunctions, or has been damaged in any manner. It must be returned to a service agent for repair or replacement in order to avoid hazard. The power cable must not be replaced by the user, as this requires the use of special tools. If the power cable is damaged, contact an authorized Service Centre. If the kettle is overfilled, boiling water may overflow. Failure to observe these cautions may result in damage to the kettle. 4 GB+INTRO 3-10-2003 11:10 Pagina 5 BEFORE USE Remove all packaging from the kettle and power base. Remove any labels from the outer stainless steel surfaces. Remove the filter by pushing as shown in fig. "Removing the scale filter" Fill the kettle and boil. The boiled water should be discarded and the kettle rinsed out with cold water. This procedure should be carried out three times, to remove any manufacturing dust, etc. After the kettle has been rinsed out, re-fit the filter (fig. 3). c a b 1 IN USE Power base with 360 access With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. Do not leave loose cord hanging over the edge of work surfaces. 1 2 2 3 Storage cable 4 Filling Remove the kettle from the base unit before filling. Open lid and fill kettle to desired level. Do not fill with less than 0, 25 litre of water to prevent the kettle running dry while operating; misuse of this kind will shorten the life of the element. [. . . ] This filter is both removable and washable. The frequency with which you will need to clean any scale deposits from your filter will depend on the hardness of water in your area and how often you use the kettle. You should remove and clean the water filter when you notice any deposits being left on the filter or if the pouring efficiency is impaired. Removing the scale filter Allow the kettle to cool down fully. Disconnect the appliance from the mains electrical supply. [. . . ]