User manual DELONGHI CTM 2223

[. . . ] The plastic bag in which the appliance was packaged should be kept out of reach of children as it poses a suffocation hazard. In order to remove the dust that may have accumulated on the appliance, simply dust it off with a soft cloth. Before inserting the plug into the electrical outlet, make certain: the voltage of the outlet corresponds to the value indicated on the information label, attached to the appliance. the electrical outlet is adequately earthed: the manufacturer declines any responsibility for the lack of observation of this norm. [. . . ] The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. If the plug is a moulded-on type the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. Only 13amp replacement fuses which are ASTA approved to B. S. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. WARNING - THIS APPLIANCE MUST BE EARTHED Green and Yellow to Earth 13 amp Fuse Brown to Live Blue to Neutral Cord Clamp 5 INSTRUCTIONS FOR USE 1. Place the slices of bread or sandwich in the racks (I), making sure they touch the bottom of the rack. Plug into a suitable mains supply socket. Turn the browning control dial (C) to required setting. Press down control lever (A) until it locks. If the toast is not brown enough, increase the toasting time. If, on the other hand, it is too dark, decrease the time. The toasting may be stopped at any time by pressing the Stop/clear button (E). In order to eliminate the "new" smell at the first use, operate the appliance without any food inside for at least 5 minutes. Note: If the appliance is not connected to the electrical outlet, the lever will not go all the way down. Using the Defrost button 1. Place the slices of bread or sandwich in the racks (I), making sure they touch the bottom of the rack. Turn the browning control dial (C) to required setting. [. . . ] · For best results use bread slices of even thickness, size and freshness · Select a lower setting if: a) using stale bread (toasts more quickly than fresh bread) b) using thin bread (toasts more quickly than thick bread) To achieve even browning, we suggest a minimum of 30 seconds between each toasting to allow the control to automatically reset. Before cleaning: remove plug, switch off at the mains and allow to cool. To clean the inside, turn toaster upside down over the sink and gently shake. Empty crumb tray regularly - see "Crumb tray" section. [. . . ]