User manual DELONGHI CTO 2003

[. . . ] The use of adapters, multiple socket units and/or extension cables is not recommended. Whenever it may be necessary to use such equipment, it is advisable to use only single or multiple adapters or extension cables which comply with the current safety standards, and make sure not to exceed the wattage limit of the adapter or extension cable. · If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. · The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of, (having removed the fuse) and not left where children might find it and plug it into a supply socket - with the obvious consequent danger. We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. Important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code: GREEN AND YELLOW BLUE BROWN EARTH NEUTRAL LIVE 13 amp Fuse Brown to Live Cord Clamp Warning Blue to Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green and yellow. The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size. If the plug is a moulded-on type the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover. Only 13amp replacement fuses which are asta approved to B. S. This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference. 5 CTO 2003 BEFORE USING FOR THE FIRST TIME · Clip excess cord into the cord storage clips underneath the toaster. · As with all new heating elements, your toaster may emit a slight burning or `new' smell when it is first switched on. This is normal and not a cause for concern. · To eliminate the `new' smell at the first use, operate the toaster on a medium setting without any without any bread inside. Ensure the room is well ventilated during this operation. TO USE YOUR TOASTER · Make sure than the ON levers (B) are at the rest position. Move the browning control dial (D) to the desired setting. · Connect the appliance to the electrical outlet. · Insert the slices of bread into the bread toasting slots (A) and lower the lever (B) until it is all the way down. [. . . ] · Do not insert forks or other utensils into the toaster in order to remove bread. As well as damaging the toaster, there is a high risk of electric shock. · Should some toast remain blocked in the toaster, remove the plug from the mains, wait for the toaster to cool down until it is safe to touch, then turn the toaster over and shake it gently. CARE AND CLEANING · Before cleaning, unplug your toaster and let it cool down. · The external part of the appliance must be cleaned with a soft cloth. [. . . ]