User manual DELONGHI D 24527D Z

[. . . ] IMPORTANT SAFEGUARDS The use of all electrical appliances implies the observance of some fundamental rules. To avoid electric shock, never immerse the cable, plug or deep fryer itself in water or other liquids. Take maximum care when the appliance is being used by or near children. When not in use and before cleaning, always unplug from the outlet. [. . . ] Never exceed this limit as oil might overflow from the bowl. The level of oil should always be between the maximum and minimum marks (H). For best results, use good quality canola oil. If lumps of fat are used, cut the lumps into pieces and melt them in another container, then pour the melted fat into the deep fryer bowl. Never melt the fat in the basket or on the deep fryer heating element (see Fig. If traces of food are left in the oil, these should be removed before heating to prolong the life of the oil. · · · · PREHEATING Place the food to be fried in the basket (S), without overfilling (max. 3lb) (1. 3 kg). Make sure the handle of the basket is correctly positioned (position 2, fig. 2). PROGRAMMING THE DEEP FRYER Use the "-/+" buttons (B) to set the temperature from 285°F to 375°F. Pressing the button once decreases or increases the temperature by 5°F (3°C). Use the MODE (C) button to access the temperature or time settings. Use the "-/+" buttons (B) to adjust cooking time from 0 to 60 minutes. Pressing the button once decreases or increases time by 30 seconds. After setting the temperature and time, press the ON/OFF button (D) (if the time has not been set, the deep fryer will not begin the heating process). The deep fryer begins the heating process. During this process, you can still modify temperature and cooking time using the "-/+" buttons (B) and the MODE (C) button to modify the selection. When the appliance reaches the set temperature, the green READY light (F) comes on and the deep fryer emits two "beeps". 7 STARTING FRYING · As soon as the green READY light (F) comes on, lower the basket (S) into the oil very slowly to prevent the hot oil from splashing or overflowing. The display (A) shows a countdown of the remaining cooking time. During this process, you can still modify temperature and cooking time using the "-/+" buttons (B) and the MODE (C) button. At the end of the countdown the deep fryer emits three beeps. If the ON/OFF button (D) is not pressed, the appliance does not begin the countdown and after 30 minutes the preset settings are restored. · A significant amount of steam will be released. · It is normal for steam to be given off from the cover and condensation to drip from the edge of the cover. · To avoid burns, never put your hands above the cover filter or deep fryer itself while in use. Before opening the cover, lift it slightly to allow steam to escape from one side. END OF FRYING · At the end of the cooking time, the deep fryer emits three "beeps". [. . . ] The oil level in the deep fryer is over the maximum limit. Food does not brown during Oil temperature is too low. cooking The oil does not heat up The deep fryer has previously been used without oil in the fryer bowl, causing the thermal cut-out to activate. The magnetic connector is not inserted correctly. "ERR" appears on the display Contact a service center. 10 LIMITED WARRANTY This warranty applies to all products with De'Longhi or Kenwood brand names. We warrant each appliance to be free from defects in material and workmanship. [. . . ]