User manual DELONGHI DD 95

[. . . ] If the plug is a moulded-on typer, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be based until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructions provided below: WARNING - THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires in the mains lead are coloured in accordance with the following code: As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or coloured green or green and yellow. [. . . ] the canister is badly positioned ¦ position it correctly 4. You are using the continuous discharge and there is a blockage in the hose or the hose goes "uphill" ¦ remove the blockage. Once the cause has been removed, the warning lamp goes off and the appliance starts working again. Before connecting the appliance to the power supply, check the following: · The mains power supply must correspond to the power supply shown on the rating plate. ⷠThe power socket and the electrical circuit must be adequate to supply the appliance. ⷠThe power socket must match the plug. The power socket must be adequately earthed. The manufacturer accepts no responsibility if these safety regulations are not complied with. This appliance is manufactured in compliance with EEC directive EN 55014 relative to the suppression of radio interference. 1) 2) 3) 4) Plug the appliance into the power socket. To switch off the appliance, turn the humidostat knob anti-clockwise to the "OFF" position. Note: For technical reasons, the humidity is expressed in levels rather than in degrees. we recommend starting with the humidostat knob set to t"CONTINUOUS". When the humidity in the room reaches the desired level, turn the knob slowly anti-clockwise until the appliance switches off. In this way, the appliance is programmed to maintain the exact humidity level that you desire. Always remove the plug from the power socket before performing any cleaning or maintenance operations. For safety, never use a jet of water to wash the appliance. Clean the appliance using a damp cloth and dry using a dry cloth. ⷠNever use petrol, methylated spirits or solvents to clean the appliance. ⷠNever spray the appliance with insecticides or similar products. These may cause the paint to flake or the pastic parts to become mis-shapen. If the filter is very dirty, wash it in warm water and rinse several times. [. . . ] ⷠDo not install the appliance in areas containing gas, oil or sulphur. Do not install the appliance near sources of heat. ⷠDo not place heavy or hot objects on the top of the appliance. ⷠClean the air filter at least once weekly. [. . . ]