User manual DELONGHI DE 250E

[. . . ] The colour of the correct replacement fuse cover is that as marked on the base of the plug. B) If your appliance is not fitted with a plug, please follow the instructins provided below: WARNING - THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Green and yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or coloured green or green and yellow. The blue wire must be connected to the terminal marked with the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red. 13 ENGLISH r always contains a certain amount of water in the form of vapour. [. . . ] · Always transport the appliance upright or resting on one side. Remember to drain the tank before moving the appliance. Wait at least 1 hour after transporting the appliance before starting it. · R290 is a refrigerant that complies with the EEC environmental standards; nonetheless, the refrigerant circuit on the machine should not be perforated. At the end of its working life, consign the air conditioning unit to a special collection centre. · The materials used for packaging can be recycled. You are therefore recommended to dispose of them in special differentiated waste collection containers. · Do not use the appliance outdoors. · Do not obstruct the air intake or outlet. · Do not store the unit in rooms or spaces measuring less than 8m3. Techni El cal service Keep the list of Service Centres and identify the Centre nearest you. ectrical connections After moving the appliance, wait at least an hour before turning it on again. Before plugging the appliance into the power socket, check that: · The mains power supply corresponds to the power supply indicated on the rating plate. · The power socket and electrical circuit are adequate for the appliance. · The power socket matches the plug. If this is not the case, have the plug replaced by a qualified electrician. · The power socket must be adequately earthed. 15 ENGLISH Installation tion the appliance in the room to be dehumidified: A free space of at least 50 cm must be left to the sides of the humidifier, so as not to block the circulation of air. The condensate can be drained in one of the following ways: A) Draining into the tank Posi The condensate can be drained directly into the tank located inside the appliance (Fig. The tank can be easily removed and has a handle making it simple to carry and empty. fig. 1 B) Continuous external draining If the appliance is to be operated for long periods but you are unable to empty the tank, it is recommended to use the continuous drain facility. 1) Remove the rubber bung from the spout. 2) Drill the inside of the drain spout using a narrow drill bit. To do this, open the door, remove the tank, pass the drain hose supplied through the opening between the door, slightly inclined, and the bottom of the appliance, then reposition the tank and insert the hose on the tank spout (Fig. 5) Make sure that the hose is not higher than the spout, otherwise water will remain in the tank; also check that the hose is not choked. [. . . ] As soon as the humidity increases above the set point, the appliance will automatically resume dehumidification operation. How to use as a ventilator 1) Plug the appliance into a mains socket. 2) The display shows "- -" to indicate that the appliance is in standby and therefore ready for operation. If the message "Ft" is displayed, empty the tank or position it correctly. 4) Press the "mode" button and choose the purification function (" " indicator light on). [. . . ]