User manual DELONGHI DEC 21

[. . . ] This amount of moisture is commonly known as the humidity. GB 18-07-2003 10:47 Pagina 12 De s c r i p t i o n / A c c e s s o r i e s 7 1 5 2 3 4 6 1. 4. Control panel Control panel cover Air outlet grille Condensate collection tank 5. 7. Lifting handle Air intake grille Air filter Accessory Description condensate drain hose (2 m. ) (some models only) rubber bung 12 GB 18-07-2003 10:47 Pagina 13 Important · Use this appliance only as described in this instruction manual. As with any electrical appliance, whilst the instructions aim to cover as many eventualities as possible caution and common sense should be applied when operating and installing this air conditioner. [. . . ] · The power socket and electrical circuit are adequate for the appliance. · The power socket matches the plug. If this is not the case, have the plug replaced by a qualified electrician; · The power socket must be adequately earthed; Failure to respect this safety rule absolves the manufacturer from all liability. This appliance is manufactured in compliance with EEC standard EN 55014 on the suppression of radio interference. · The cable must be replaced by approved service personnel only. 13 ENGLISH GB 18-07-2003 10:47 Pagina 14 Installation tion the appliance in the room to be dehumidified: A free space of at least 50 cm must be left at the front of the humidifier, so as not to block the air outlet. A space of around 5-10 cm should be left at the rear of the appliance for aeration. Condensate can be drained choosing one of the following ways: A) Draining into the tank The condensate can be drained directly into the tank located inside the appliance (fig. The tank can be easily removed and has a handle making it simple to carry and empty. Posi fig. 1 B) Continuous external draining If the appliance is to be operated for long time periods but you are unable to empty the tank, you are recommended to use the continuous drain facility. 1) Drill the inside of the drain spout using a 6 mm. For models without drain hoses supplied, we suggest you to purchase a rubber hose around 2m long, with an internal diameter of 9. 5 mm. 3) Make sure that the hose is not higher than the spout, otherwise water will remain in the tank; also check that the hose is not choked (Fig. You will need it to plug the hose or close the spout if you revert to draining into the tank (see point A). NO YES fig. 3 14 GB 18-07-2003 10:47 Pagina 15 How to dehumidify How to dehumidify 1) Plug the appliance into a mains socket. 2) Check that the "tank full/tank missing" light is off. 3) Select the or according to the desired dehumidifying power; the dehumidification standby light remains on during the first 3 minutes (safety device), after which the dehumidification light switches on. 4) The humidistat knob is used to adjust the humidity level as desired (MIN/MED/MAX). When the knob is on MIN, the dehumidifier will slightly reduce the humidity in the room; on MAX, on the other hand, the appliance will considerably reduce the humidity in the room. Then turn the humidistat to one of the positions available. Turn the humidistat to the MAX position. When the humidity has reached the required level (this can take several weeks), slowly turn the humidistat knob anticlockwise until the dehumidifying light goes out. [. . . ] · To remove the air filter, extract by pulling it as shown in fig. · Use a vacuum cleaner to remove dust accumulations from the filter. If the filter is very dirty, wash in warm water and rinse several times. The temperature of the water should not exceed 40°C. [. . . ]