User manual DELONGHI DEL 1000

[. . . ] Do not operate the appliance if damaged 2. FITTING THE FEET Remove the feet and the castors from the polystyrene packing. Fit the castors to the spindles on the feet and push firmly until they click into position (fig. Pull each castor to check that it is fitted correctly. [. . . ] Adjusting the thermostat When the room has reached the required temperature, slowly turn the thermostat until the indicator light goes off (or to the position marked by a click) and no further. The set temperature will then be regulated automatically and kept constant by the thermostat. Frost protection function With the thermostat in position and the switches pressed, the appliance maintains the room at a temperature of about 5°C, preventing freezing with minimum energy consumption. 7) To set the heating periods proceed in the following way: I Setting the Timer - if fitted Set the timer at the correct time. turn the numbered dial of the time-clock in a clockwise direction until the number 11 coincides with the reference mark on the clock. Set the time period during which you wish the appliance to work by pushing * 3 HRR/HOR 5-11-2003 8:34 Pagina 4 ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer IMPORTANT: Never for any reason cover the appliance during operation as this could lead to dangerous overheating. 4 5707000100/11. 03 the notches towards the centre. Each notch corresponds to a 15 minute period. At this point sections wiIl be visible, corresponding to the working periods. Once the lever has been positioned on the heater wiII automatically work only during the preset time periods. (Important: the plug must remain connected to power supply). To change programmed operating times, just puII notch back to original position and reset timer for new functioning period. To override the timer, place the lever in position . TURBO HEATING Some models are fitted with a heating fan which heats the room more quickly. To turn this function on, push the button into the position. Important: a safety device cuts in and switches off the appliance if it overheats due to an accumulation of dust on the air intake and output grills. Take the heater to an authorised service agent who will reset the device. Models with "Tilt-switch" Some models are fitted with a tilt-switch turns the appliance off if it should fall over. To restart the appliance, simply place it upright again. MAINTENANCE Before carrying out any operation on the radiator, unplug from the electric mains and wait for it to cool. The oil-filled electric radiator requires no particular maintenance. [. . . ] - This radiator is filled with a precise quantity of oil and repairs which require it to be opened must be carried out exclusively by the manufacturer or an authorised service centre. In the case of oil leaks, contact the manufacturer or the authorised service centre. - When scrapping the appliance, respect legislation on the disposal of oil. - Do not use the appliance in rooms with a base area of less than 4 m2. [. . . ]